Security: Video

Port Mapping Table dialog box displays the port mapping for the IP addresses of the configured devices in your BVMS. Be aware that this option was removed starting with BVMS 11.1

IVA pro Buildings pack and Traffic pack on CPP14 use the following resolutions: 1280x720 resolution for 25/30 fps base rate,  1024x576 resolution for 50/60 fps base rate.

Remote Connect Lite service enables connection between Divar network/hybrid, cloud and client software.

If cleaning the bubble is required, use the following procedures and comply with all the warnings listed in this article.

Perhaps you are wondering how to set the maximum retention time on a Divar Network? Some of our customers asked about this option. Well, in DIVAR Network and Hybrid there is not retention time. But you can set the automatically deleting time, that is more or less the same.   Step-by-step guide:   Open one Browser and type your device IP address Login with the administrator account Go to Settings > Storage > Recording Fill in the box with the desired automatic deletion time   Another option is to make this change directly in the local interface of the unit.

Use the CTFID tool (Configuration Tool for Imaging Devices) for configuring the camera. Find in this article the download link and the release note.

Regular BVMS 12.0.1 installer will not run on any DIVAR IP all-in-one platform. The upgrade shall be performed via DIVAR IP System Manager application. Keep in mind: If you want the latest version of BVMS, it must be downloaded and applied with the latest version of System Manager.

This article shows from where can I find my Bosch Remote Portal ID.

This feature is not available in BVMS 10.1. You cannot do it automatically for multiple cameras. You can do it one by one manually through Config Client.

This camera does not have the auto-focus functionality in the same sense as Autodome / Mic cameras.

The initial idea of the Project Assistant is nicely summarized in the video from this article

This article contains all the steps to set up a Video Verification service (triggered by intrusion panel) in Bosch Alarm Management.

This article gives you the solution to fix the behavior when the recording doesn't work for VG4 AutoDome camera and when the Bosch logo is displayed in the cameo

BVMS OPC server restricts the use of some symbols in the camera names

This article explains what you can do when the message:“The number of windows in this view exceeds the maximum limit set in the system parameters” appears in Operator Client with minimum 2 Monitors.

This will let you call up cameras on an Allegiant monitor output across the network to a remote site.

Health monitoring with Remote System Management is very easy, as in one page you have an overview of the state of all DIVAR IPs connected to your Remote Portal and then, drilling down a level, you have an instant overview of the state of the cameras connected to the selected DIVAR IP. A service is available to setup health alerts for devices via email, so you are informed when any emergencies pop up.

Upon powering on the DIVAR IP all-in-one 7000 system you hear FAN spinning normal, LEDs are blinking at normal frequency and there are no error beep codes. However, there is no display when connected via VGA (or) DVI (or) DP. Check out this article and find out how to fix this!

In this article is explained step by step how to collect System Manager logs from your DIVAR IP all-in-one 4000 & 6000.

This article is applicable for all the requests related to third party products integrated in Bosch Video Management System Software over ONVIF.