This article describes the considerations that need to be taken into account when designing a video surveillance system that is suitable for person identification.
Check the sample script from this article. It is not a working script, that can be used directly. Follow the instructions in comments of the script to tailor it for your use.
If the Host Type was set to other value than “Factory Default” for DSA E2800 and you want to integrate it with BVMS, the targets will most likely not be scannable and there will be no recordings at all.
This article contains a step-by-step guide which explains how you can perform a full factory default of DSA E2800 via SANtricity Storage Manager by using Script Editor
BP+ (Baseline Profile +) is available in any of the new ARM based chipset encoders, like the VIP-X1 XF. BP+ is needed for compatibility with Divar and hardware decoders, for example, theVIP XD decoder.
This article explains how you can configure the iSCSI ports of your DSA E2800 dual or single controller and afterwards configure it in BVMS Configuration Client.
The purpose of this article is to help you find the customer number and the material/ serial/ commercial type number of your Bosch device in different ways.
Follow this article and find out what to do if the Bosch VRM Monitor page does not open correctly, but instead displays an Error and the video is always Black.
Use the Microsoft Event Logging! When an error occurs, you can use the event log to help determine what conditions caused the error and identify the context in which it occurred.
The purpose of this article is to provide the step-by-step process of adding drives to a DIVAR IP 7000 R1 (DIP-7080-00N) Recording appliance and configure initial RAID setup on it.
This article describes how you can remove the existing BVMS or BVMS viewer configuration and generate a fresh configuration again in a situation the customer/installer is unable to remember the Admin login credential to the BVMS/ BVMS viewer.
