Security: Video

This article provides an ansswer if can I create an Intelligent Insights report containing hourly data for every day.

This message may occur due to the conflict between the Device access option set for your Videojet and the Security option set in Configuration Manager.

This article provides an answer regarding what to do in case if a  colleague from the same company claimed a license with a wrong Remote Portal account.

In this article can be found the solution regarding the black image of the ONVIF camera added in VSG in BVMS Operator Client.

This article provides causes and solutions regarding  the date and time indication inside the Image Panes  which are not visible in BVMS Operator Client.  

This article provides solution regarding 3rd party camera which is  added in VSG and is not displayed in the Device Tree from BVMS Configuration Client.

This article shows from where can I find my Bosch Remote Portal ID.

"An unexpcted error occured. Press F5 to go back to the operation mode selection page and retry. If the issue persist, contact technical support." Windows Server 2022, which is running on these machines is trying to contact their server, which in some cases (still being investigated why) is failing.  

This article presents how to find the Intelligent Insights version installed on my unit.  

If for any reason, later on the DIVAR IP needs to be removed from Bosch Remote Portal connected via System Manager, follow the steps from this article.

This article shows the blueprints for the three operation modes that the DIVAR IP supports, combined with Remote System Management. They show the capabilities and limitations of Remote System Management in each of the modes.

Health monitoring with Remote System Management is very easy, as in one page you have an overview of the state of all DIVAR IPs connected to your Remote Portal and then, drilling down a level, you have an instant overview of the state of the cameras connected to the selected DIVAR IP. A service is available to setup health alerts for devices via email, so you are informed when any emergencies pop up.

This article explains why cannot select the 1080 resolution in the dewarp mode of FLEXIDOME panoramic 5100i 12MP.

Configuration Manager 7.60 by default will only trust CA signed certificates. Changing the security requirements will change the behavior of how CM displays the connection/access.

Have a look at this article and learn how to fix the Add Scriptlet button which does not become active. It stays grayed out. Same happens with ClientScript and ServerScript.

If you want to be able to replay the recording for the complete retention time, you should use VRM replay. VRM should be accessible and added to the VSC

"Show VCA items" is a function which works in Internet Explorer 11 with the Bosch MPEG ActiveX installed. Due the end-of-life of Internet Explorer, this function is no longer available on Microsoft Edge.

Upon powering on the DIVAR IP all-in-one 7000 system you hear FAN spinning normal, LEDs are blinking at normal frequency and there are no error beep codes. However, there is no display when connected via VGA (or) DVI (or) DP. Check out this article and find out how to fix this!

Can I mask areas that should not trigger an alarm (e.g. false detection due to sun reflection)?

At startup, a black screen is showing up and it is impossible to boot into the BIOS or attempt a reset by pressing the F7 key. How to fix this?