Security: Video

This article explains how to configure Monitor B output for Divar AN 3000-5000.

The Divar AN 3000/5000 features the ability to ping an IP address, thus allowing the technician to verify that the workstation that is to connect to the Divar can be seen on the network. Please note that this only checks the connection from the DIVAR to the Workstation. Ping operates by sending Internet Control Message Protocol (ICMP) echo request packets to the target host and waiting for an ICMP echo reply. The program reports errors, packet loss, and a statistical summary of the results.

To get multiple events in one alarm, please enable Event Batching in the related Service.

🛈 Port Forwarding Allows remote computers (for example, computers on the Internet) to connect to a specific computer or service within a private local-area network (LAN). In a typical residential network, nodes obtain Internet access through a DSL or cable modem connected to a router or network address translator (NAT/NAPT). Hosts on the private network are connected to an Ethernet switch or communicate via a wireless LAN. The NAT device's external interface is configured with a public IP address. The computers behind the router, on the other hand, are invisible to hosts on the Internet as they each communicate only with a private IP address. When configuring port forwarding, the network administrator sets aside one port number on the gateway for the exclusive use of communicating with a service in the private network, located on a specific host. External hosts must know this port number and the address of the gateway to communicate with the network-internal service. Often, the port numbers of well-known Internet services, such as port number 80 for web services (HTTP), are used in port forwarding, so that common Internet services may be implemented on hosts within private networks.

This article explains what to do when a device scan from within Milestone XProtect is not exposing all Bosch cameras in the network.

XProtect offers 3 different modes of metadata streaming. What are the differences there?

Check this article and find the compatibility matrix between Bosch cameras and Milestone

The article describes how to receive analytic events from Bosch cameras in Milestone XProtect.

This article describes how to secure the data connection between Bosch cameras and Milestone's XProtect by the use of 'Authority-signed Certificates' 

This article describes how to use Milestone's PTZ  "Home" position with Bosch PTZ cameras.

Flexidome 8000i or other future cameras with WLAN option enabled (default ON) in an IPv6 network environment: no IPv4 possible. What to do?

Follow the steps from this article and find out how you can license BVMS Viewer v.11.0  or above for free.

If you are still using BVMS version <9.0 and you want to replace a faulty device without loosing recording, please follow the steps below.

Note that this procedure applies only from VRM version 3.10 onwards.

According to the Release Letter for V3.1.1 and V.3.2.0 - "SNMP- No traps are launched for HDD status changes and recording stops"

Username Administrator is not available from the drop-down list, and any generated backdoor password will not work & only one user (other than Administrator) is available in the drop-down list

The timeline is present, but the recordings appear to be black for all cameras.

Under sunlight conditions Dinion IP ultra 8000 MP may give an excessive blue contouring around white objects.

The LTC keyboard is conceived for analog systems, where you have a monitor and you add a keyboard for control and connect it directly to the camera.

Dinion IP starlight 6000 HD/ Dinion IP ultra 9000 MP is a fixed camera, not a PTZ camera. The camera is only capable of e-PTZ (Electronic Pan, Tilt and Zoom).