If the Host Type was set to other value than “Factory Default” for DSA E2800 and you want to integrate it with BVMS, the targets will most likely not be scannable and there will be no recordings at all.
In this article we cover the following basic questions:
How to Factory Default a NetApp E-Series unit by using BOSCH tools and NetApp WEB GUI?
How to download the NetApp Support Bundle of a reachable online NetApp Storage Array
Network switch has port security on and shuts down a NetApp iSCSI data port (e.g. CH3).
This article is only relevant in aspects of network security / port security where MAC addresses are analysed.
Some network security applications are capable of sniffing network packets thoroughly enough to pick up MAC addresses on E-Series Controller ports that are not seen in the Storage Array Profile data.
With the DSA E2800 Bosch introduced Multipathing. It is a fault-tolerance technique that defines more than one physical path between the camera and its iSCSI storage devices through redundant network connections.
When using this feature, recording of video data and replaying video data is possible even in case of an iSCSI controller failure. To ensure also that outages of infrastructure equipment (e.g. Switch) could be covered, we recommend following Interconnection.
This article describes the easiest method for adding Expansion shelves to a Base unit DSA E-Series E2600, E2700 or E2800.
This article also applies when:
The amount of storage is overloaded and you need additional storage after fully populating the base shelf.
1. Configuration Manager
2. Configuration Client which is included with BVMS
3. Santricity Software
This article contains 2 options describing the way you can find the Firmware version of your DSA unit, in case the Central Technical Support team is asking you about it or if you simply want to find it by yourself. Check out this article!
This article presents what should we check first if Channel 5 & 6 of DSA E2800 are showing as disconnected:
Verify if the expansion slots are connected correctly (page 21)
Afterwards, wait a few minutes until they load up, and only then start the DSA S2800.
Now, you can check in the Configuration Manager to see if the IP addresses need to be changed.
Once you verify that they are correct, you can add the Device in Configuration Client.
This article presents where you can find and download the Firmware for NetApp DSA unit.
Depending on the version you need, you can access this E-Series SANtricity OS Controller Software Link for Downloads.
This article explains where to find the Serial-No. of a system. The BOSCH sticker is most important.
For registration and NetApp case creation of the DSA E2700 and the DSA E2800 units only the NetApp S/N of the Controller base unit is relevant.