Security: Video

In many cases a minimum and maximum retention time needs to be defined in a video surveillance systems due to legal requirements. While the minimum retention time defines the time period for how long video recordings need to be stored, the maximum retention time defines after which period of time the recordings have to be deleted. Thus, the minimum retention time is going to influence the amount of storage needed. The higher the minimum retention time the more storage space is required.

This attached document describes how Bosch Building Technologies handles the life-cycle of the BVMS, BIS, AMS, and APE, and in which state a specific release can reside.

This article explains if camera credentials are needed for the IVA Configuration plug-in.  

The pop-up dialog window message: "Setup has detected a pending restart.  Please reboot the system and rerun the installation"  appears when attempting to run the valid BVMS windows installer package.

This article presents what's new in Video Security 3.7 for Windows, Android and iOS.

The Release Letter for CPP 7.72.1118 provides information about the dependencies between firmware versions for a better understanding of the upgrade process of devices with older firmware.

This troubleshooting guide, will guide you through the recovery steps of a DIVAR IP 6000 or 7000, DIVAR IP 6000 R2 or 7000 R2, without video data loss

The timeline is present, but the recordings appear to be black for all cameras.

You may need the SNMP MIB file when you are trying to monitor the camera through a Bosch or 3rd party software. This article aims to describe how to find and enable the SNMP on a Bosch camera.

Find out from this article what is the domain name used to connect your DIVAR to the Remote Portal

If you have CPP4 cameras with 6.11 firmware (FW) version and you need to upgrade them to the latest version, normally you have to upgrade to an intermediate firmware version first. But where you can find this firmware ?

This article contains the scriplet that on Input sends a RCPP command on Input to another camera to close its Relay 1.

This article is a step-by-step guide regarding how to change the Bosch Camera name.

This article explains what is the Intelligent Dynamic Noise Reduction (iDNR) in Bosch cameras.

This article explains what is the difference between video coding H264 and H265 (Bosch cameras).

This article explains if is it possible to enable Remote Desktop on DIVAR IP all-in-one 6000 and connect on it remotely.

When doing a pull point subscription, at the Start of the events Rule Engine/LineDetector/Crossed is missing, even though the rule is configured, and is given in the GetEventProperties response. The topic name space for RuleEngine/ FieldDetector/ ObjectInside works as expected.

In order to determine the Time Zone values, perform the bit mask operation of the flag value with the combined bit mask value 0x1F800000 as shown below. Bits 23-28 correspond to the Time Zone bits in the Flags.

Limited user is available on DIVAR IP all-in-one 4000, if the unit has HDDs inside. Every setup with DIVAR IP System Manager, on any DIP (AIO 7000 GEN 3, AIO 4000, AIO 5000, AIO 6000) that is "00N" (without HDDs) will fail and result in a lack of a "limited user" and "kiosk mode", if you do not insert the HDDs and perform the necessary steps from the manual.

The following instruction describes how to configure a data partition from RAID 5 to RAID 6 on the DIVAR IP all-in-one 7000 4th generation. It is not possible to directly migrate from RAID 5 to RAID 6, so the first step is to delete RAID 5 and then create RAID 6.