Security: Video

How to detect in an easy and convenient way if the camera suffers from a failing shutter mechanism which can result in white or ghost images? This article helps you to identify if the camera possibly suffers from a random failing shutter which uses the FFC (Flat Field Correction) instead of waiting for the FFC taking place approx every ~10min, you can now fire it on command.

If you want to control the camera from a DIVAR wired through a VJD 3000, you have to configure the VJD and the DIVAR as well. Below you will find the steps which will help you to set up your devices.

This article provides causes and solutions regarding the error code 49 Invalid Credentials when trying to login to LSA management software.

This article explains how you can  monitor the hardware health status of the DIVAR IP storage devices → Measure can be taken to repair the device if something fails.

This article lists the initial troubleshooting steps for issues with ONVIF cameras, added to BVMS system as Live Only ONVIF cameras. The specific point in this scenario is VSG is not used.  

Find out in this article the Bosch Inteox cameras portfolio with the New Features

This article explains how to connect an INTEOX camera to the S&ST ecosystem using Configuration Manager (7.20 and later).

This article describes how to deploy Microsoft Security Updates on a BRS Appliance

Starting with firmware 7.10, an option to export from RAM recording buffer allows recording exports on the fly without requiring an SD card or external iSCSI storage.

This article explains that if deactivating the RTSPS protocol in the camera network settings, there will be no live stream in BVMS Operator Client.  

To set up certificate-based authentication with Bosch, you'll typically need to follow the steps from this article.

Keep an eye on your customers’ sites, and verify on-demand if the site is clear before the personnel enters.

Using the following command you can reset the result of People counting via SDK: http://<IP_address>/rcp.xml?command=0x0b4a&type=P_OCTET&direction=WRITE&num=1

This article contains the steps to focusing a Bosch Box camera: set the Back Focus to the Center position and focus on a specific area

Waiting For Power - Invalid PoE source was detected during the auto-negotiation. The Pan Motor, Tilt motor, and the heaters will be disabled.

This article explains how to find and calculate the specific size of BVMS logs on your server when the log starts to overwrite your own data.

Find out from this article what you should do to fix green Image panes in BVMS

This article explains how to configure the Bosch ITS and NTCIP licensed versions of IP moving cameras to respond to National Transportation Communications ITS Protocol (NTCIP).

Port Mapping Table dialog box displays the port mapping for the IP addresses of the configured devices in your BVMS. Be aware that this option was removed starting with BVMS 11.1

Question Why I cannot see my camera in the Logical Tree from Operator Client? Answer Please make sure that you have done all the steps below accordingly. Normally, to be able to view a camera in the Operator Client, you need to: Go to the Maps and Structure tab from Configuration Client. Drag and drop the camera in question from the Device Tree to the Logical Tree. Save and Activate the changes. This step is very important because otherwise, you will not be able to see the changes in Operator Client, even though the first 2 steps were carried out in Configuration Client.