Security: Video

Check this article and find the difference between unmanaged sites and subsystems (BVMS)

New check in BVMS Configuration Client has been implemented, which blocks the disabling of the "Secure connection" if camera port 1756 is disabled. This should prevent the camera from getting "unreachable" by miss-configuration of the administrator. 

The MG Camera Name and Number Setting (BVMS Configuration Client, under MG Camera Settings) was not designed for BVMS Operator Client cameo, but in fact for the CPP-Enc type of decoder like VJD-3000.

Welcome to the 3.5 release of Video Security for Windows, Android and iOS. There are new features in this release, some of the highlights are explained within this article.

Please configure the same time zone on the PC, download the Remote Portal activation file again and then you will be able to load it into Config Client and license the system.

The Bosch camera can make up to two (2) recorded tours. A recorded tour saves all manual camera movements made during the recording, including its rate of pan, tilt and zoom speeds, and other lens setting changes.

You should only subscribe directly to this article (Option 1) or to the software_release_notification label (Option 2) and you will receive a notification in your inbox every time when a new Software version is released and added to the lists within this article.

Glutton (German: Vielfraß) defines and prevents a camera or multi-channel encoder from mounting and consuming  a large number of  blocks in a very short time.

If replacing a defective camera, the camera must be the same IP address as the defective device, and it cannot contain a GUID from a different VRM.

The configured camera TCP port is used from the BVMS Operator Client to the camera. This port is used by the BVMS Operator Client as a destination port. The source port is dynamic and therefore, it cannot be adjusted.

Hash Tag "#" is one of the few special characters, which is accepted by the camera, but it cannot be accepted on BVMS side (in order to connect to the camera) — due to the limitations of communication specifics some BVMS components are using. And as a result, communication might not work properly and "No connection" warning message in Operator Client image pane and black screen might occur

When you request to reset the DIVAR password, the Central Technical Support team provides you with the unlock codes. The unlock codes received from the CTS are valid only for 1 Day. Moreover, please make sure that the date displayed on the Live monitor matches the date you requested the password reset.

If you forgot the password of your BVMS — Bosch Video Management System and you want to reset its password, the Central Technical Support Team can help you.

If you forgot the password of your Bosch IP recorder and you want to reset its password, the Central Technical Support Team can help you.

If you have CPP4 cameras with 6.11 firmware (FW) version and you need to upgrade them to the latest version, normally you have to upgrade to an intermediate firmware version first. But where you can find this firmware ?

Find out from this article if there are restrictions of VRM Configuration utility pre-installed on DLA

This script will make your encoder to toggle relay 1 only when IVA rule #1 alarm is active.

This article guides you to easily find the connector’s pinout of FLEXIDOME Panoramic 5100i IR camera

Follow these instructions from this article if the ‘error code=1’ appears in Configuration Client - License Manager during the license activation process.