Security: Video

This article is a step-by-step guide regarding how to change the Bosch Camera name.

In order to determine the Time Zone values, perform the bit mask operation of the flag value with the combined bit mask value 0x1F800000 as shown below. Bits 23-28 correspond to the Time Zone bits in the Flags.

The following instruction describes how to configure a data partition from RAID 5 to RAID 6 on the DIVAR IP all-in-one 7000 4th generation. It is not possible to directly migrate from RAID 5 to RAID 6, so the first step is to delete RAID 5 and then create RAID 6.

The thermal mode is saved in the preposition settings. If you have changed the thermal mode of the camera in the Picture Settings Thermal page and you also want the Thermal color mode to apply to the existing saved pre-position, you have to re-save the pre-position again.  

The Table view provides the option of presenting a summary of specific settings for individually selected devices in the form of a clearly arranged  table.  The content of all main tabs and sub-tabs can be exported in *.csv format.

In order to add the Subject Alternative Name, you can use "Bosch Configuration Manager" or the camera's web page using latest Firmware

This article provides you with information related to the Windows Firewall, how to access, configure and adjust it.

The following instruction describes how to configure the data disk in a RAID1 configuration on the DIVAR IP all-in-one 4000. Is important to keep in mind that the configuration of the data disks in RAID1 will cause DATA LOSS on the disks used to create the RAID configuration

The article describes how to ensure the delivery of the IVA events to Genetec Security Center via Hybrid Driver ( Other ( CPP13 or newer) driver )

This article is a step-by-step guide about how to update the BIOS on the DIVAR IP all-in-one 7000 4th gen (DIP-74xx).

The ASUS Inband Tool is the preferred log collection tool, all relevant logs can be gathered from there for ASUS Tech Support. LSI Storage Authority, LSA for short, can be found on the DIP74xx’s Windows desktop. 

With the release of the DIVAR IP all-in-one 7000 gen4 (DIP-74xx), a new tool is available for health monitoring and log gathering, it essentially replaces SuperMicro’s SuperDoctor5; the ASUS Inband Tool. This tool operates as a service on the DIP and provides a webpage with hardware health monitoring options, hardware status details, and hardware information, as well as an option to export logs and run reports.

By default the maximum number of shown results in the forensic search execution is 1000 and after 200 found results a warning message is shown. This article describes how to change those values.

NetApp® from time to time provides new HDD firmware for the various HDD / disk models. In January 2024 an NetApp Knowledge Base Article was created that needs to be taken into consideration as well.

The calibration can be done by using already recorded videos, as is demonstrated in the video below. Either video recorded on the camera's SD card or on a recorder can be used. This can save calibration time and can be done by a single person.

This interface is designed to provide applications an API for controlling Virtual Inputs. To access an existing Virtual Input the application has to know the unique authentication token of the Virtual Input which is used for both authentication and identification.

The default behavior of VRM is to redirect requests from "HTTP" to "HTTPS" via the HSTS setting. Never change VRM or any device settings via CM if they are managed by BVMS - BVMS will revert the settings back to previous state as set in BVMS Cc

At some point of the troubleshooting process, the customers might be asked to force the VRM to do a full initial discovery.

In this scenario, an alarm button is connected to the Adam unit and when this input is activated (close or open), a full screen camera image shows on the display. The display is always logged in the Operator Client for live camera view on the DIVAR IP 7000 AIO.