After a power outage/ reboot, all PTZ cameras will get back to their zero-point (home) position. If your PTZ camera was installed looking at a wall, in case of a power outage it will return to its home position where its image is pointing at the wall.
This article responds to the following questions:
At what temperatures does the factory installed heater turn on and off?
Does the blower turn on and off with the heater or does it run continuously?
What is the power consumption of the heater?
What is the power consumption of the blower?
New check in BVMS Configuration Client has been implemented, which blocks the disabling of the "Secure connection" if camera port 1756 is disabled. This should prevent the camera from getting "unreachable" by miss-configuration of the administrator.
During the authentication process with Bosch cameras to a RADIUS server, the event “5400 Authentication failed” occurs. Find out from this article what you can do in this case.
Due to an error in the software interface to the secure element chip on the cameras, the chip can be permanently damaged. Follow this article and find out the mitigation of this behavior
This article provides the following solution regarding: Bosch CPP7.3 cameras: DHCP does not follow the standard protocol (FW v7.85.0016)
Upgrade your camera to FW 7.86.0019 and perform a factory default (access Download Store here).
The time effort to fix this in older FW will be planned for early March 2023.
"Show VCA items" is a function which works in Internet Explorer 11 with the Bosch MPEG ActiveX installed. Due the end-of-life of Internet Explorer, this function is no longer available on Microsoft Edge.
Does your camera show you the live view as in the image below?
During day time (Color-Mode), the image is good, but as soon Night-Mode kicks-in and the IR-LED's turn on, the reflection is noticed.
By setting a low Frame rate and a long GOP, this affects the replay.
On the flip side high frame rate and short GOP can show pulsing Live video:
30 FPS @ GOP 10 = 3 I-Frames per sec (the video could appear pulsing; the Monitor refresh rate could also play a role here)
When using Bosch cameras for IVA Calibration performed with Bosch Configuration Manager 7.70.0090, the Scenario selection is not there anymore, and by default it selects bird's eye view.
After upgrading the camera firmware to version 7.81.0060 and higher, the camera display name become smaller in the font size. This is observed in CPP 6 and CPP 7 Bosch IP cameras.
This web page is for information only, so none of the fields displayed can be edited.
Although this information is also included in the Log files, this view provides some valuable information at a quick glance.
“Error: Discontinuity in network stream!” appears randomly on the monitor/s connected to the VIDEOJET Decoder 7000 (7513). What could be the likely cause of this?
After configuring the Virtual mask in the web browser of Bosch CPP7.3 camera and afterwards going back to the Live view, the Virtual mask appears as Privacy mask and is not transparent and other inappropriate behaviors have been noticed. This happens on the Bosch CPP7.3 cameras that have FW version older than v.7.86.0019
