Security: Video

A password prevents unauthorized access to the device. You can use different authorization levels to limit access. Proper password protection is only guaranteed when all higher authorization levels are also protected with a password. Therefore, you must always start from the highest authorization level when assigning passwords. This article will guide you step by step to set the destination password for decoders.

*Firmware 9.10 must be installed prior to installation of this firmware 9.51. Firmware download location: Download Store or on the product page > Downloads: VIDEOJET decoder 8000 page

Before you can operate your VIDEOJET decoder 7000/ 8000 within your network, it must have a valid IP address for your network and a compatible subnet mask. This articles explains how you can change the IP Address of VIDEOJET decoder 7000/ 8000 using Configuration Manager.

From this article you will find out how to set up the IP Matrix configuration on the VIDEOJET decoder 7000 (VJD-7513) using Configuration Manager.   The built-in IP Matrix functionality, together with a connected keyboard, allows VIDEOJET decoder 7000 to run as a stand-alone system. An operator can manage up to 32 cameras via the keyboard without any PC or management system required. System setup is quickly done with Configuration Manager. After that, no PC is required to run the IP Matrix   Note: According to the Release letter (Firmware 9.51) of VJD-7513, VIDEOJET decoder 7000 supports IP Matrix application as built-in feature. According to the Release letter (Firmware 54.8.02) of VJD-7000, IP matrix remote monitor is only possible with UDP. TCP not supported. ** VJD-7000 can be used as an extended monitor to IP Matrix in single and quad view. Please check also the following article and find out: Which are the system requirements for configuration/ operation of VIDEOJET decoder 3000/ 7000/ 8000?   A single system can support: 2 physical monitor displays One KBD-Universal XF keyboard 32 cameras 32 camera sequences 9 favorite views

If you forgot the service level password for you Bosch IP camera and you want to reset its password, the Central Support Team can help you.

This article provides you the way you can set the VIDEOJET decoder 8000/ 7000 (VJD-8000/ VJD-7513) to factory default. Article requirements: VIDEOJET decoder 8000/ 7000 Keyboard monitor

The purpose of this article is to help you find the customer number and the material/ serial/ commercial type number of your Bosch device in different ways.

If your VIDEOJET decoder does not seem to work properly, most likely it is because the software (SW) version used is not compatible with the firmware (FW) version of your device.

If you want to control the camera from a DIVAR wired through a VJD 3000, you have to configure the VJD and the DIVAR as well. Below you will find the steps which will help you to set up your devices.

This article aims to define the way you can display camera video via decoders. Moreover, fifteen different settings scenarios and their effects will be outlined for the live video to be displayed through the decoder.