Security: Video

Find out from this article which Bosch encoders and decoders are compatible with BVMS

*Firmware 9.10 must be installed prior to installation of this firmware 9.51. Firmware download location: Download Store or on the product page > Downloads: VIDEOJET decoder 8000 page

If you forgot the service level password for you Bosch IP camera and you want to reset its password, the Central Support Team can help you.

This article provides you the way you can set the VIDEOJET decoder 8000/ 7000 (VJD-8000/ VJD-7513) to factory default. Article requirements: VIDEOJET decoder 8000/ 7000 Keyboard monitor

If your VIDEOJET decoder does not seem to work properly, most likely it is because the software (SW) version used is not compatible with the firmware (FW) version of your device.

This article aims to define the way you can display camera video via decoders. Moreover, fifteen different settings scenarios and their effects will be outlined for the live video to be displayed through the decoder.

If the ‘decoder offline’ message occurs during the FW upgrade from 54.7 to 54.8,  try to use another version of Configuration Manager, or remove the password temporarily.

It is not possible to have a custom layout, such as 2 X 3. Supported layouts depend on physical characteristics of monitor and on the set aspect ratio. For example, for a monitor with optimal resolution 1920x1080 the following layouts are supported. Other resolutions may have different values. Any resolutions are supported.

“Error: Discontinuity in network stream!” appears randomly on the monitor/s connected to the VIDEOJET Decoder 7000 (7513). What could be the likely cause of this?

Starting with firmware 6.51.0026, clearing passwords was changed to only reset service user level password.

This article presents the the successor of VIDEOJET Decoder 7000 (VJD-7513). The replacement of it is F.01U.407.935 / VJD-7523.

The RTC_AUDIO_LOUDSPEAKER_ON_OFF flag is not activated.

The MG Camera Name and Number Setting (BVMS Configuration Client, under MG Camera Settings) was not designed for BVMS Operator Client cameo, but in fact for the CPP-Enc type of decoder like VJD-3000.

VIDEOJET decoder 3000 is only capable of decoding H.264 video.

Find out from this article what to do when the Decoder VJD-7513 with FW 10.31.0005 is displayed in BVMS but: First monitor connected on HDMI to HDMI on monitor shows images. Second monitor connected via a USB-C-to-DP cable to the DP port on the monitor shows no output on the second monitor.

“Error message” occurs while trying to upgrade the Firmware of VJD-7513 from firmware version 9.51 to 10.23. Configuration Manager 7.61 is used.

This article provides the Firmware  of the VJD-7513 is also suitable for the successor model VJD-7523.

This message may occur due to the conflict between the Device access option set for your Videojet and the Security option set in Configuration Manager.

This article contains the RCP+ commands (VJD 7513) to change the layout and see what camera you want to be displayed