Security: Video

This article provides the Firmware  of the VJD-7513 is also suitable for the successor model VJD-7523.

Follow the steps below from this article to collect the configuration data file and the maintenance log file that might be requested by Central Technical Support team for troubleshoot & support purposes.  

This article explains how to integrate the Bosch MIC IP 7000 HD camera series into any existing analog CCTV system using the Bosch VIDEOJET decoder 3000. The most common integration scenarios are listed below: Simple integration using direct connectivity to analog monitor and joystick, typically found in single camera installation (for example, mobile surveillance vehicles) Integration into an existing analog matrix switcher typically found in large installations (such as for city surveillance)

This article recommends what convertors to use with the Videojet Decoder 7523 to ensure compatibility with KBD Universal XF.

Find out from this article which Bosch encoders and decoders are compatible with BVMS

If you forgot the service level password for you Bosch IP camera and you want to reset its password, the Central Support Team can help you.

Central Technical Support team may ask you to provide them with the logs from VIDEOJET decoder 7000 (VJD-7513). Follow this article and find out how to do this!

Starting with firmware 6.51.0026, clearing passwords was changed to only reset service user level password.

The information regarding the ports can be found in BVMS – Configuration Manual (page 366), should the customer use BVMS as a VMS.

The RTC_AUDIO_LOUDSPEAKER_ON_OFF flag is not activated.

This article contains the RCP+ commands (VJD 7513) to change the layout and see what camera you want to be displayed

If the ‘decoder offline’ message occurs during the FW upgrade from 54.7 to 54.8,  try to use another version of Configuration Manager, or remove the password temporarily.

It is not possible to have a custom layout, such as 2 X 3. Supported layouts depend on physical characteristics of monitor and on the set aspect ratio. For example, for a monitor with optimal resolution 1920x1080 the following layouts are supported. Other resolutions may have different values. Any resolutions are supported.

“Error: Discontinuity in network stream!” appears randomly on the monitor/s connected to the VIDEOJET Decoder 7000 (7513). What could be the likely cause of this?

The MG Camera Name and Number Setting (BVMS Configuration Client, under MG Camera Settings) was not designed for BVMS Operator Client cameo, but in fact for the CPP-Enc type of decoder like VJD-3000.

This article presents the the successor of VIDEOJET Decoder 7000 (VJD-7513). The replacement of it is F.01U.407.935 / VJD-7523.

Find out from this article what to do when the Decoder VJD-7513 with FW 10.31.0005 is displayed in BVMS but: First monitor connected on HDMI to HDMI on monitor shows images. Second monitor connected via a USB-C-to-DP cable to the DP port on the monitor shows no output on the second monitor.

“Error message” occurs while trying to upgrade the Firmware of VJD-7513 from firmware version 9.51 to 10.23. Configuration Manager 7.61 is used.

If your VIDEOJET decoder does not seem to work properly, most likely it is because the software (SW) version used is not compatible with the firmware (FW) version of your device.

A password prevents unauthorized access to the device. You can use different authorization levels to limit access. Proper password protection is only guaranteed when all higher authorization levels are also protected with a password. Therefore, you must always start from the highest authorization level when assigning passwords. This article will guide you step by step to set the destination password for decoders.