Security: Video

Based on the symptoms of no steaming video, a blank diagnostic log and the message below in the logs, there could be a few possible problems. These would be internal hardware issues.  

This web page is for information only, so none of the fields displayed can be edited. Although this information is also included in the Log files, this view provides some valuable information at a quick glance.

Find out from this article what to do if the System Overview of Bosch camera shows the I/O controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the IR controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the Motor controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the SC or Camera controller FW version as zeros

Any modification of the DIP unit IP, adding of a Network Dongle, moving of the ethernet cable in another network switch, even temporary, will stop the communication between the VRM and BVMS and could lead to issues. (e.g. No recording /iSCSI Target unreachable etc.)

When using Bosch cameras for IVA Calibration performed with Bosch Configuration Manager 7.70.0090, the Scenario selection is not there anymore, and by default it selects bird's eye view.

This FAQ article contains a lot of questions and answers related to Bosch Remote System Management service 

This article summarizes the BVMS design details, and serves as a guide to planning a BVMS system with Bosch cameras and storage. It focuses on BVMS combined with the VRM.

In this article, the technology behind IVA Pro Buildings, IVA Pro Traffic and IVA Pro Intelligent Tracking will be explained, as well as the differences between each other, and towards the more traditional IVA Pro Perimeter and classical IVA.

This article describes which camera settings influence the performance of Essential or Intelligent Video Analytics in Bosch IP cameras, and what the best practices are.

This article describes how to benchmark Video Analytics and differentiate video analytics solutions.

This article shows what to do in case the following message occurs: "Could not add the following devices"  when adding IP cameras FW 7.87  to BVMS 12.0.

Find out from this article what should be done when the MIC IP STARLIGHT 7100I cameras pan but do not tilt

BVMS Configuration Client or Operator Client does not display correctly on the DIVAR IP 4000 AIO when opened from the Kiosk mode and appears oversized in fullscreen.

The wiring and installation details in this guide are based on common practices used at sites to ensure proper surge and lightning suppression.

The timeline is present, but the recordings appear to be black for all cameras.

At some point, the Central Technical Support team could ask you to provide them with a Configuration Manager table view export, for further investigation of your devices, such as a full overview of the installed cameras or with the cameras with a specific problem. This article will help you to learn how to do this export.

When logging into BVMS Operator Client, there is an alarm showing up: “System Error - Server alarm queue capacity reached”. Find out from this article what could be the cause and how to solve this.