What should you do if you tried to drag an drop the device to the cameo window from BVMS Operator Client and instead having the video, it displays the logical tree?
The "storage state failure" alarm doesn't always mean a recording error unless there is a gap at the time of the error for that camera that reported it.
It is an error of the iSCSI protocol; it means that when the camera releases the connection for a certain block it has not received a response back from the iSCSI target in a certain time.
Find out from this article what can you do if the Windows product key cannot be activated on your DIVAR IP and if this message was displayed: "This key didn't work, please check it and try again, or try a different key."
This article explains where to find the Serial-No. of a system. The BOSCH sticker is most important.
For registration and NetApp case creation of the DSA E2700 and the DSA E2800 units only the NetApp S/N of the Controller base unit is relevant.
Can I display more than 1 camera on a single Monitor of Decoder VJD-7513 in BVMS 11.0 when an alarm is triggered?
System Overview:
BVMS 11
1 monitor connected to 1 x VJD-7513 that is part of a Monitor Group
The monitor has a layout consisting of several image panes
Desired status: when an alarm is triggered → pop up the image of the 4 cameras on the same decoder monitor
This article contains a step-by-step guide which explains how you can do the setup for the camera's live view image pane to be displayed in full screen in the Operator Client if a motion alarm is triggered on that camera,
Check this article and find out what you can do if you are using one Divar network 2000 and you have a new Flexidome IP 5000i IR camera, but you cannot add it to the Divar because it is not displayed in “Detection” > “Device search” screen.
Starting with BVMS 10.0, ONVIF encoder events can be retrieved from VSG or ONVIF encoder directly. Additionally to ONVIF profile S, BVMS 10.0 supports ONVIF profile T.
Remote Portal's Remote Connect service allows connection to your devices through the Remote Portal with your client software, such as Video Security Client and Video Security App.
Before you can operate your VIDEOJET decoder 7000/ 8000 within your network, it must have a valid IP address for your network and a compatible subnet mask.
This articles explains how you can change the IP Address of VIDEOJET decoder 7000/ 8000 using Configuration Manager.