Security: Video

Prior to receiving any type of support, the customer needs to be informed that he/she must have a valid SMA (Software Maintenance Agreement)

The entire BVMS installation package, available on the downloadstore, contains the client as well as the server components. When a BVMS client needs to be deployed, all of this data (over 2.5GB) needs to be copied to the target workstation, which can be quite a challenge in some environments.

This article contains the CGI commands that help you to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper during boot-up

This article explains what is BVMS Operator Client and how this work with cameras in live view mode. 

Check this article and find out if you can add and see a BVMS 11 system running on a DIP in MVS webpage as unmanaged site

This article describes the mechanism of ANR 2.0 and how it can be set up. In the following ‘camera’ is used as a representative for all video source devices supporting ANR 2.0.

It is advised to use Bosch tools like the Configuration Manager to configure the camera, that does not allow for issues like XSS

This article describes the behavior of the cameras when two power inputs are connected to the camera.

🛈 Port Forwarding Allows remote computers (for example, computers on the Internet) to connect to a specific computer or service within a private local-area network (LAN). In a typical residential network, nodes obtain Internet access through a DSL or cable modem connected to a router or network address translator (NAT/NAPT). Hosts on the private network are connected to an Ethernet switch or communicate via a wireless LAN. The NAT device's external interface is configured with a public IP address. The computers behind the router, on the other hand, are invisible to hosts on the Internet as they each communicate only with a private IP address. When configuring port forwarding, the network administrator sets aside one port number on the gateway for the exclusive use of communicating with a service in the private network, located on a specific host. External hosts must know this port number and the address of the gateway to communicate with the network-internal service. Often, the port numbers of well-known Internet services, such as port number 80 for web services (HTTP), are used in port forwarding, so that common Internet services may be implemented on hosts within private networks.

New generation of Bosch cameras: no default password, the user has to create one

The DIVAR IP units are prepared from production to use at first setup the port 8454.

This article contains the options for physical/ default reset of Bosch Inteox cameras.

The Embedded Login Firewall of all Bosch IP cameras, introduced with firmware version 6.30, consists of a two-level system which makes use of two integrated functional modules.

Find out from this article which Bosch encoders and decoders are compatible with BVMS

The wiring and installation details in this guide are based on common practices used at sites to ensure proper surge and lightning suppression.

MQTT is a Client Server publish/subscribe messaging transport protocol.

If cleaning the bubble is required, use the following procedures and comply with all the warnings listed in this article.

With the DSA E2800 Bosch introduced Multipathing. It is a fault-tolerance technique that defines more than one physical path between the camera and its iSCSI storage devices through redundant network connections. When using this feature, recording of video data and replaying video data is possible even in case of an iSCSI controller failure. To ensure also that outages of infrastructure equipment (e.g. Switch) could be covered, we recommend following Interconnection.  

BVMS v10.1 and  BVMS v11.0 come with a checkbox where you can logon to the Operator Client with Windows Credentials. If you want to use this function, you need to set up the BVMS Configuration Client and browse the AD users-groups. Then, the users can sign in to Operator Client with their Windows-Credentials. 

Port Mapping Table dialog box displays the port mapping for the IP addresses of the configured devices in your BVMS. Be aware that this option was removed starting with BVMS 11.1