Security: Video

With fw7.70 a new feature was introduced that allows you to tune the scene for Day and Night separately using 2 custom scene modes. This article explains how to switch the scene modes Custom mode#1 & Custom mode#2 based on Day or Night for Bosch cameras

This article lists how to configure ANR feature in BVMS and how to set up correctly the iSCSI and direct replay. 

In this article, the technology behind IVA Pro Buildings, IVA Pro Traffic and IVA Pro Intelligent Tracking will be explained, as well as the differences between each other, and towards the more traditional IVA Pro Perimeter and classical IVA.

This article describes the easiest method for adding Expansion shelves to a Base unit DSA E-Series E2600, E2700 or E2800.   This article also applies when: The amount of storage is overloaded and you need additional storage after fully populating the base shelf.   Article requirements: 1. Configuration Manager 2. Configuration Client which is included with BVMS 3. Santricity Software   Step-by-step guide      

Find out from here what is VCA (Video content analysis) and how you can stop this setting.

In order to increase system security in BVMS, it is recommended to set the Global CHAP password. This article contains the configuration steps for an existing fully operational BVMS 11.x system with no CHAP password configured.

This article informs about improvements in firmware handling and new security mechanisms that help our customers to increase security related to firmware updates and IP camera protection.

This articles gives a short introduction to scripting alarm and counter tasks with Intelligent and Essential Video Analytics in FW 7.60. It also provides a broad selection of example scripts for explanation as well as including real world application examples.

This article describes which camera settings influence the performance of Essential or Intelligent Video Analytics in Bosch IP cameras, and what the best practices are.

This article describes the camera tamper detection options available with FW 6.30: Scene too dark / bright, global change, reference image check.

This article provides an overview of object classification, describes how to configure it and what the limitations are.

The attached documents should help you to make the upgrade process as smooth as possible. The upgrade itself is not restricted to BVMS software only. The supported software and firmware versions can be found in the release notes of the related BVMS version.

Please keep in mind that for SNMP v3 only the the Standard MIB II file is supported. This means that only general network device performance monitoring parameters can be requested. There is no Bosch Private MIB II extension for SNMP v3. 

A network management server can poll the health status of a device via SNMP requests. This article shows how to configure Bosch cameras in order to be able to answer to such requests.

The default Community Strings for Bosch cameras is - public. To change it, please follow the steps below.

This article describes all the steps that will help you to create iSCSI Virtual Disk/LUNs after replacing an HDD on a DIVAR IP 5000 AIO.

Starting with BVMS 11.0, the license activation is done via Bosch Remote Portal. A transfer of the license from the Bosch Software License Manager System (SLMS) to the Bosch Remote Portal is required for every BVMS system to be upgraded from 10.1 to 11.0

This article explains how to use the settings as per the devices current configured capabilities if you just added a device to BVMS, you get the possible stream options as per a “Config table” known to BVMS.

This article provides a step-by-step guide about how you can disable UPnP of Bosch IP cameras & multicast scan from Configuration Manager. One of the reason why UPnP (Universal Plug and Play) is enabled in our devices is because ONVIF uses this to scan the ONVIF device in the network.

Bosch Remote Portal connects you to your Bosch Security devices from anywhere and lets you perform remote administration and maintenance anytime