Security: Video

This article explains what can you do when ‘Authentication failed’ message occurs when accessing VSG in BVMS v11.0

This article explains how you can change the relay mode back to automatic via a script executed when the relay open event is triggered.

This article explains how to use the settings as per the devices current configured capabilities if you just added a device to BVMS, you get the possible stream options as per a “Config table” known to BVMS.

No. It is not possible to disable the time synchronization function of BVMS. It is only possible to configure a single time server per BVMS system to be used as time source for the VRM encoders.   You can check the article below, if needed: How to configure time services in a BVMS environment?

What can be done when 3rd party camera is flashing between image and Bosch logo in Operator Client?

Check this article and find out if you can add and see a BVMS 11 system running on a DIP in MVS webpage as unmanaged site

The BVMS 11.1.1 Configuration Manual contains the lists for all components of BVMS, the ports that must be open within a LAN. You can find the used ports list starting with page 346 from the   BVMS Configuration Manual.

This article explains what to do i f there is an unexpected shut down (e.g. instant power cut) and you have to apply the BVMS licenses again on your unit

Check this article and find the difference between unmanaged sites and subsystems (BVMS)

This article explains what you can do when the message:“The number of windows in this view exceeds the maximum limit set in the system parameters” appears in Operator Client with minimum 2 Monitors.

When using ANR function in combination with 'alarm only' recording , recording 1 is with only the motion recorded.

Check the sample script from this article. It is not a working script, that can be used directly. Follow the instructions in comments of the script to tailor it for your use.  

According to the Release Letter for V3.1.1 and V.3.2.0 - " SNMP- No traps are launched for HDD status changes and recording stops "

Check this article and find out  what the Start Manual Recording button of VRM Camera Cameo does in BVMS Operator Client

Follow these instructions from this article if the ‘error code=1’ appears in Configuration Client - License Manager during the license activation process.

Find out from this article what  does mean the sand clock (hourglass) symbol showed in the Operator Client Logical tree

This article explains in which conditions t he users and Admin user receive Alarms in BVMS Operator Client.

Find out from this article the steps that should be considered for a planned shutting down and powering up of your BVMS system

If the Host Type was set to other value than “Factory Default” for DSA E2800 and you want to integrate it with BVMS, the targets will most likely not be scannable and there will be no recordings at all.

This article gives you the solution when the link to Remote Portal from  BVMS v11.0 License Manage is redirecting to the 404 Not Found page