Security: Video

This article answer to the question: "Why the ‘SD card Status’ is missing in GUI of MIC IP starlight/ultra/inteox 7100i camera?"

This article explains how you can change the codec for your DINION IP 3000I IR via web GUI

This article is a step-by-step guide regarding how to factory default the FLEXIDOME IP starlight 8000i with the reset button (Hard reset)?

Find out from this article if it is a cause for concern if the temperature of FLEXIDOME IP 5000i IR (NDI-5503-AL) is higher than other cameras.

Camera integrated as NTCIP with SUNGUIDE software works great, but as ONVIF there are issues with the focus. When trying to adjust the focus from the SunGuide software, there are no changes with the camera image.

Find out from this article how can you avoid the MIC Inteox & Starlight 7100i camera wipers getting stuck.

This article it is about analog control system connected directly to the MIC IP serial port. The serial com ports of traditional analog systems head end control systems connect directly to the RS485 input of the MIC IP models listed within this article.

After configuring the Virtual mask in the web browser of Bosch CPP7.3 camera and afterwards going back to the Live view, the Virtual mask appears as Privacy mask and is not transparent and other inappropriate behaviors have been noticed. This happens on the Bosch CPP7.3 cameras that have FW version older than v.7.86.0019

Essential Video Analytics (VCA) does not work as soon as the image is rotated to 90 degrees (under Initialization) and the camera is restarted. Additionally, the movements or objects are not recognized. As soon as you set "Rotate image" to 0 degrees and set it back to 90 degrees, motion detection via Essential Video Analytics suddenly works again.

This article provides you the solution when the MIC IP starlight 7100i camera wiper stops on the screen. Furthermore, you will learn how to perform a physical reset of the camera.

This article provides the following solution regarding: Bosch CPP7.3 cameras: DHCP does not follow the standard protocol (FW v7.85.0016) Upgrade your camera to FW 7.86.0019 and perform a factory default (access Download Store here). The time effort to fix this in older FW will be planned for early March 2023.

If  ‘Calibration upload to camera failed’ for CPP7.3 & CPP13 Bosch cameras please follow the below steps: Upgrade Configuration Manager to version 7.61. This must be used in combination with CPP13 Firmware 8.45 or later  

Find out from here what is VCA (Video content analysis) and how you can stop this setting.

In this article you can find the actions you need to do in order to solve the zoom speed for AUTODOME NDP-7512. A customer could observe a difference in zoom speed in comparison to the previous generation

This article shows how  the image quality of AUTODOME inteox 7000i & comparison with AUTODOME 5000i IR camera image can be improved.

If you are wondering where can be configured the field of view and focus of the FLEXIDOME IP starlight 8000i, without having to touch the camera or lens, this article will provide you the answer. 

Follow this article if you would like to optimize the image quality of your AUTODOME IP 5100i camera

In principle, the Autodome starlight 5100i IR camera (NDP-5523-Z30L) may only be operated with switches, midspans or PoE injectors that meet the EEE802.3bt standard! - Or use 24VAC.**

This article contains the CGI commands that help you to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper during boot-up

PTZ camera (Autodome IP starlight) doesn't move in Pan or Tilt direction. This is a basic troubleshooting guide that will help you to fix this issue.