Security: Video

The thermal mode is saved in the preposition settings. If you have changed the thermal mode of the camera in the Picture Settings Thermal page and you also want the Thermal color mode to apply to the existing saved pre-position, you have to re-save the pre-position again.  

The inconsistency in the tamper detection functionality could be due to various factors. Follow this article for more details.

Be sure that the MIC-7100i camera is configured in BVMS Configuration Client with "Bosch-AutoDome Bilinx" protocol and not with "Bosch-AutoDome" protocol or other options from the list.

Please note that the relay output of the IO Alarm card is a dry contact relay (with 24VAC/VDC, 5 A). In order to control another circuit that has a 230V you can't do that directly because its higher than it was design for. In order to safety control a 230V, you could use a 24V on that output and control an additional/external relay: powering its coil this relay could switch the 230 circuit of the washer.

In the winter period, if there is no PAN functionality in the camera and despite this, the TILT still works, this could be caused by the snow or ice that might be stuck between the static part of the camera and the moving camera head. Find out from this article how you can prevent this happening.

Bosch requires the installer to provide the specified power mentioned on the product spec sheet and labels. While taking into consideration the POE standards. Bosch doesn't support out-of-spec operation of our cameras as we cannot guarantee proper functionality in such circumstances. Thus, we will not be providing out-of-spec voltage or power values at this stage.

The RCPP command to enable/ disable the privacy masks is CONF_PRIV_MSK_POLY - 0x0bd8. Follow this article to see the rcpp command to enable & disable the privacy mask of a Bosch camera (moving or fixed).

The maximum zoom speed in the GUI is operational but is only applicable during "manual control." When the operator calls for 30x, the zoom speed has to remain constant. While the speed may not be as rapid as anticipated, it is essential to understand that this camera model is already operating at its optimum capacity.

‘Status 11’ means that the wiper is blocked and cannot move freely or cannot move at all. Please check if the wiper is working properly and can move freely.

In case you have noticed a gap between the left and right of the lens installation, this might cause improperly focus for the camera's image. Therefore, please proceed as explained in this article.

Please note that this recommendation might help, but cannot guarantee the high quality of the image. It depends on the camera FoV and the environment where the camera is installed.

Mercury vapor lights are banned in many countries. There are a variety of phosphor coatings used by different lighting brands resulting in different color temperatures.

Should the inverter produce a sine/sinusoidal wave, a square wave or other?

The MIC IP fusion 9000i supports only simplified Chinese language. There is no option to select traditional Chinese in the menu.

This article contains some hints about what to do when the FLEXIDOME IP 3000i IR does not provide Analog stream or it provides a grey image

Find out what can you do when in large parts of the zoom range, the MIC IP starlight 7100i camera simply does not focus; this is the same for manual PTZ and pre-sets.

This article mentions that the material from which the Surface Mount Box of the NBE-5503-AL is made of is Aluminum.

Follow this article if you would like to optimize the image quality of your AUTODOME IP 5100i camera

This article describes what shoud be done to achieve an Optical Zoom for FLEXIDOME IP 3000i IR camera.

If the CPP6, 7 and 7.3 cameras no longer have a live image or there is a delay in the image, and the Internet connection has been tested and is within normal parameters, it would be good to check if the cameras have the latest current firmware version 7.86.0020. This firmware version solves a 100% CPU load issue for CPP6, 7, 7.3 from firmware 7.82 to 7.86.19