Security: Video

Hash Tag "#" is one of the few special characters, which is accepted by the camera, but it cannot be accepted on BVMS side (in order to connect to the camera) — due to the limitations of communication specifics some BVMS components are using. And as a result, communication might not work properly and "No connection" warning message in Operator Client image pane and black screen might occur

Starting with firmware 6.51.0026, clearing passwords was changed to only reset service user level password.

The method from this article shows you how to generate an updated certificate for Bosch IP Camera's and VRM Servers

The audio file can be played using the RCP+ command CONF_AUDIO_OUTPUT (0x09b9), payload=4 (Sample), which can of course also be sent to the device itself using ATSL scripting.

Does your camera show you the live view as in the image below? During day time (Color-Mode), the image is good, but as soon Night-Mode kicks-in and the IR-LED's turn on, the reflection is noticed.

The detection distance (based on the pre-defined requirements*) depends on the focal length and the size of the of the gun. 

This article provides solution for Bosch PTZ camera & Genetec VMS when camera's image does not follow the correct field of view on the map.

To set up certificate-based authentication with Bosch, you'll typically need to follow the steps from this article.

Bosch will undertake a cybersecurity best practice by disabling certain ports on the camera by default. This best practice is being undertaken to reduce potential attack surfaces and limit the exposure of sensitive services, as mentioned in our Data Security Guidebook since years.

This web page is for information only, so none of the fields displayed can be edited. Although this information is also included in the Log files, this view provides some valuable information at a quick glance.

Find out from this article what to do if the System Overview of Bosch camera shows the I/O controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the IR controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the Motor controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the SC or Camera controller FW version as zeros

When using Bosch cameras for IVA Calibration performed with Bosch Configuration Manager 7.70.0090, the Scenario selection is not there anymore, and by default it selects bird's eye view.

Both RJ45 and M12 plug connectors are available with IEC 11801:2002 Cat5 compliance. This further simplifies the concurrent use of both connector types within a single system.

After a power outage/ reboot, all PTZ cameras will get back to their zero-point (home) position. If your PTZ camera was installed looking at a wall, in case of a power outage it will return to its home position where its image is pointing at the wall.

The RCP documentation can be found in the Firmware .zip file on the product page.

Find out from this article if is it possible to get a raw video stream from a Bosch camera

The IEEE standards in computer networks ensure communication between various devices; it also helps to make sure that the network service, i.e., the Internet and its related technologies, must follow a set of guidelines and practices so that all the networking devices can communicate and work smoothly. Depending on the camera model, the PoE IEEE standard used could be different.