Security: Video

To guarantee high quality imaging through the entire range of products, Bosch Security Systems uses a Common Product Platform (CPP).

This article explains where to find the Serial-No. of a system. The BOSCH sticker is most important.  For registration and NetApp case creation of the DSA E2700 and the DSA E2800 units only the NetApp S/N of the Controller base unit is relevant. 

This is a living document and the list will be constantly updated. Details can also be found in the BOSCH Product catalogue:

This article presents what parameters to set in BVMS on a new Stream Quality profile.

At the initial setup of DIP 7000 AIO R3, when the Software Center has to be installed,  you might get the “Certification Check Failed” error message.

This article provides an answer if the  an OS upgrade to Win2016 can be performed on old DIP 3000, DIP 6000 or 7000 R1.

Can I display more than 1 camera on a single Monitor of Decoder VJD-7513 in BVMS 11.0 when an alarm is triggered?   System Overview: BVMS 11 1 monitor connected to 1 x VJD-7513 that is part of a Monitor Group The monitor has a layout consisting of several image panes Desired status: when an alarm is triggered → pop up the image of the 4 cameras on the same decoder monitor

This article contains a step-by-step guide which explains how you can do the setup for the camera's live view image pane to be displayed in full screen in the Operator Client if a motion alarm is triggered on that camera,

Windows 11 Pro is now officially supported as OS for BVMS 11.1.1 Operator Client

The purpose of this article is to help you disabling the compass character from the Screen Display (OSD) of the Bosch PTZ camera via its web interface

This article explains step by step how to set Bosch Cameras & Divar network 2000 & UML-245-90 monitor to be able to retrieve audio.

Check this article and find out what you can do if you are using one Divar network 2000 and you have a new Flexidome IP 5000i IR camera, but you cannot add it to the Divar because it is not displayed in “Detection” > “Device search” screen.

At first sight, you might think that the model is the correct one that shows in the Datasheet, but the Video card is smaller than the DIP Slot.

 This article shows the keyboard shortcuts that can be used by operators when operating the BVMS system. 

Starting with BVMS 10.0, ONVIF encoder events can be retrieved from VSG or ONVIF encoder directly. Additionally to ONVIF profile S, BVMS 10.0 supports ONVIF profile T.

Remote Portal's Remote Connect service allows connection to your devices through the Remote Portal with your client software, such as Video Security Client and Video Security App.

Before you can operate your VIDEOJET decoder 7000/ 8000 within your network, it must have a valid IP address for your network and a compatible subnet mask. This articles explains how you can change the IP Address of VIDEOJET decoder 7000/ 8000 using Configuration Manager.

The normal process is to enable Complete memory dump, this will capture in the event there is an Unhandled Exception.

This article explains how you can change the relay mode back to automatic via a script executed when the relay open event is triggered.

The browser supported by Bosch cameras depends on the CPP that camera belongs to and on the Firmware version the camera has.. In web browsers that do not support MPEG-ActiveX, VCA configuration is only possible via Configuration Manager.