Security: Video

PTZ camera (Autodome IP starlight) doesn't move in Pan or Tilt direction. This is a basic troubleshooting guide that will help you to fix this issue.

All of camera block FW updates require an additional step for the FW upgrade process, which is described in the documents attached.

This article is meant to provide you with the step-by-step guide to activating the wiper and the white lights illuminator option, if your camera is equipped with both of them.

This article provides you the solution when the MIC IP starlight 7100i camera wiper stops on the screen. Furthermore, you will learn how to perform a physical reset of the camera.

See what you can do when MIC 7000i with FW 7.72 shows blurred images. After restart, the quality of the image is good for a short time, but the issue reappear.

Find out from here what is VCA (Video content analysis) and how you can stop this setting.

This article explains how to fix the behavior of MIC IP 7000i/9000i Bosch camera when is out of focus during a rapid zoom

Causes   When camera is set to auto track (by web interface) to "auto"-> IVA is detecting an object but camera is not following. Auto tracking works and metadata is displayed only on a stored preposition.   Solution   There was a change introduced starting with FW v.7.70. The new feature is:   i-Track only starts on VCA-Alarm.   You can either program this on presets, e.g a detection field or if you want to have Itrack active regardless of its position, you need to activate "global VCA" and assign task detection area "whole screen" now only activate iTrack "AUXON78" so the eye is in the corner, and your iTrack will always be on sharp   Note: IVA must be active for at least one preset scene in the VCA page on the Settings tab. If IVA is configured for one scene, then all other scenes have Intelligent Tracking enabled by default. If a scene, however, has Motion+ or IVA 5.5 Flow activated, then Intelligent Tracker is disabled for these scenes. Please refer also to the attached document.

This article explains how you can prevent the privacy mask from moving down and up when zooming in and out for AUTODOME and MIC cameras.

This article provides a solution to the intermittent focus issues for MIC 7000i series and for the Optical video in the MIC 9000i

The MinIris and MaxIris values could be configured when the camera is mounted and installed in specific lighting conditions .

This article contains the CGI commands that help you to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper during boot-up

Check out this article and find out  the streaming capabilities of CPP7 & CPP7.3 Bosch IP cameras

This article contains several common questions and answers about Firmware of Bosch MIC IP Starlight 7000i cameras

The 95 W midspan is a high-power PoH (Power Over HDBase T) device that provides data and power between an Ethernet switch and an IP camera.

This article it is about analog control system connected directly to the MIC IP serial port. The serial com ports of traditional analog systems head end control systems connect directly to the RS485 input of the MIC IP models listed within this article.

Camera integrated as NTCIP with SUNGUIDE software works great, but as ONVIF there are issues with the focus. When trying to adjust the focus from the SunGuide software, there are no changes with the camera image.

The LTC keyboard   is conceived for analog systems, where you have a monitor and you add a keyboard for control and connect it directly to the camera.

This article presents solution regarding how to stop "rtp.p_type 97" (OSD or Video Authetication packet) on a CPP4 and CPP7.3