Security: Video

This article provides possible causes and solutions regarding FLEXIDOME Inteox 7100i (CPP13) - calibration lost using FW 8.45.0032.

Please note that the relay output of the IO Alarm card is a dry contact relay (with 24VAC/VDC, 5 A). In order to control another circuit that has a 230V you can't do that directly because its higher than it was design for. In order to safety control a 230V, you could use a 24V on that output and control an additional/external relay: powering its coil this relay could switch the 230 circuit of the washer.

This article gives you the solution when the link to Remote Portal from BVMS v11.0 License Manage is redirecting to the 404 Not Found page

When integrating Intelligent Insights with a self-signed certificate, the BVMS operator client always shows an error message when opening a widget in the BVMS operator client image pane. Find out from this article how to solve this behavior!

WD MSD-064G IP SECURITY MICROSD CARD does not support lifespan check for Bosch CPP4 cameras

Find out what to do when you enable SingleKey ID and you are no longer able to connect to Remote Portal using the password.

MVS gets error message “Videoprovider not available” when trying to log on. Also, the BVMS Configuration Client shows the X mark on the MVS. What to do?

The Image Stabilization cannot be used in combination with VCA tasks, with the various MIC-7100i models. Turning Off the image stabilization will solve this behavior.