This article helps you to activate the purchased licenses (MBV-XSITEPLU-100) if the unmanaged site expansion licenses were not introduced During the introduction of BVMS 10.0 (BVMS Plus)
This article explains what you can do when the message:“The number of windows in this view exceeds the maximum limit set in the system parameters” appears in Operator Client with minimum 2 Monitors.
If you use the firmware files that are dedicated to a certain CPP platform, then you will need to select simultaneously only the cameras with the same CPP platform.
One of the main bugfix reasons to use VRM 03.71.0029 is a fix in regards to correct display and replay of recorded clips in continuous and alarm recording mode.
This article describes the considerations that need to be taken into account when designing a video surveillance system that is suitable for person identification.
Check the sample script from this article. It is not a working script, that can be used directly. Follow the instructions in comments of the script to tailor it for your use.
If the Host Type was set to other value than “Factory Default” for DSA E2800 and you want to integrate it with BVMS, the targets will most likely not be scannable and there will be no recordings at all.
This article explains how you can configure the iSCSI ports of your DSA E2800 dual or single controller and afterwards configure it in BVMS Configuration Client.
Our portfolio contains quite a variety of (mobile) video clients and applications. To get a fast first overview we created the attached table to compare the most important ones.
This article describes how you can remove the existing BVMS or BVMS viewer configuration and generate a fresh configuration again in a situation the customer/installer is unable to remember the Admin login credential to the BVMS/ BVMS viewer.
This article lists the initial troubleshooting steps for issues with ONVIF cameras, added to BVMS system as Live Only ONVIF cameras. The specific point in this scenario is VSG is not used.