Security: Video

If you cannot access any program from kiosk mode or they are randomly opened on your DIVAR IP AIO, this happens because you double click on the icons.

Importing a foreign configuration should recover a RAID configuration (in case the RAID is not corrupt) This option must be performed before creating a new VHD. This option may restore all of the video and data on the drives.

In this article can be found how to add a license in Remote Portal and activate it on a DIVAR IP AIO connected to Remote Portal via System Manager.

Health monitoring with Remote System Management is very easy, as in one page you have an overview of the state of all DIVAR IPs connected to your Remote Portal and then, drilling down a level, you have an instant overview of the state of the cameras connected to the selected DIVAR IP. A service is available to setup health alerts for devices via email, so you are informed when any emergencies pop up.

This article shows the blueprints for the three operation modes that the DIVAR IP supports, combined with Remote System Management. They show the capabilities and limitations of Remote System Management in each of the modes.

With the release of System Manager 2.0, the DIVAR IP systems can now be connected to the internet for maintenance and management, using Bosch Remote Portal.

Upon powering on the DIVAR IP all-in-one 7000 system you hear FAN spinning normal, LEDs are blinking at normal frequency and there are no error beep codes. However, there is no display when connected via VGA (or) DVI (or) DP. Check out this article and find out how to fix this!

In this article can be found which is the max. iSCSI recording sessions of DIVAR IP AIOs.

This article lists the concrete instructions for collecting logs or other important information for issues with DIVAR IP. We will classify the different issue scenarios . Depending on the issue, this article lists the required logging to start the initial troubleshooting process.

This article contains the username and password of SuperDoctor 5 for Divar IP 7000 AIO

At first sight, you might think that the model is the correct one that shows in the Datasheet, but the Video card is smaller than the DIP Slot.

This article explains what action should be done for DIVAR IP 7000 Gen 3 before collecting IPMI logs

Follow the steps from this article and learn how you can create RAID 1 on your unit.

Follow this step-by-step guide and learn how to configure RAID 5 on your DIVAR IP AIO 7000 GEN3.

⚠️ NOTE: This procedure is the same for all 2U and 3U systems and is also applicable for DIP 7000 AIO GEN3 , except 3108 FW might be different, depends on the exact model.

This article explains what to do if there is an unexpected shut down (e.g. instant power cut) and you have to apply the BVMS licenses again on your unit

This guide covers the necessary software configuration procedures to recover from the following failure scenarios: One Drive Failure, Two Drive Failure or LSI Controller Card Replacement ( Post Physical Installation)

This step-by-step guide will help you to perform the upgrade of BVMS from v.10.1 to v.11.0 on a DIVAR IP 7000 AIO GEN 3 (DIP-7380-00N)

When upgrading a DIVAR IP AiO to BVMS 11, the information from this article should be considered.

This article explains how you can solve the situation when Config Client shows Access denied message under the Physical capacity field, when trying to access the DIP-7000 AIO.