Security: Video

If the CPP6, 7 and 7.3 cameras no longer have a live image or there is a delay in the image, and the Internet connection has been tested and is within normal parameters, it would be good to check if the cameras have the latest current firmware version 7.86.0020. This firmware version solves a 100% CPU load issue for CPP6, 7, 7.3 from firmware 7.82 to 7.86.19

Based on the symptoms of no steaming video, a blank diagnostic log and the message below in the logs, there could be a few possible problems. These would be internal hardware issues.  

This web page is for information only, so none of the fields displayed can be edited. Although this information is also included in the Log files, this view provides some valuable information at a quick glance.

Find out from this article what to do if the System Overview of Bosch camera shows the I/O controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the IR controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the Motor controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the SC or Camera controller FW version as zeros

When using Bosch cameras for IVA Calibration performed with Bosch Configuration Manager 7.70.0090, the Scenario selection is not there anymore, and by default it selects bird's eye view.

In this article, the technology behind IVA Pro Buildings, IVA Pro Traffic and IVA Pro Intelligent Tracking will be explained, as well as the differences between each other, and towards the more traditional IVA Pro Perimeter and classical IVA.

This article describes which camera settings influence the performance of Essential or Intelligent Video Analytics in Bosch IP cameras, and what the best practices are.

Both RJ45 and M12 plug connectors are available with IEC 11801:2002 Cat5 compliance. This further simplifies the concurrent use of both connector types within a single system.

The wiring and installation details in this guide are based on common practices used at sites to ensure proper surge and lightning suppression.

This article contains different Q&A regarding the Camera certificate in Config. Manager & WEB GUI: size limit, supported formats and limitations.

After a power outage/ reboot, all PTZ cameras will get back to their zero-point (home) position. If your PTZ camera was installed looking at a wall, in case of a power outage it will return to its home position where its image is pointing at the wall.

Never lose track of an object of interest! Intelligent Tracking automatically zooms in to and follows a selected Intelligent Video Analytics object as far as possible with the camera.

The RCP documentation can be found in the Firmware .zip file on the product page.

This feature is not available in BVMS 10.1. You cannot do it automatically for multiple cameras. You can do it one by one manually through Config Client.

Find out from this article if is it possible to get a raw video stream from a Bosch camera

Due to the product design, the configuration of the NIR-50850-MRP (IP IR Illuminator 5000 MRP) is done only in the web browser. Also, this article contains a short explanation about how to setup the NIR-50850-MRP (IP IR Illuminator 5000 MRP).