If you are wondering where can be configured the field of view and focus of the FLEXIDOME IP starlight 8000i, without having to touch the camera or lens, this article will provide you the answer.
Using the following command you can reset the result of People counting via SDK: http://<IP_address>/rcp.xml?command=0x0b4a&type=P_OCTET&direction=WRITE&num=1
By setting a low Frame rate and a long GOP, this affects the replay.
On the flip side high frame rate and short GOP can show pulsing Live video:
30 FPS @ GOP 10 = 3 I-Frames per sec (the video could appear pulsing; the Monitor refresh rate could also play a role here)
If you will try to use these languages as name stamp for Bosch cameras, it will display squares or not the word/s itself at all.
This is not a bug or a fault, Hebrew & Thai characters are not available for the on-screen display.
By design, the Dual-Recording feature is specific only in Bosch Cameras. 3rd party cameras are integrated into Bosch Systems like BVMS-VRM via our Video Streaming Gateway (VSG)
The Release Letter for CPP 7.72.1118 provides information about the dependencies between firmware versions for a better understanding of the upgrade process of devices with older firmware.
When the camera operates in automatic Night-Mode and the switching interval is too fast the camera built in protection mechanism will intervene to prevent premature wear of the mechanical IR-Cut filter.
"Show VCA items" is a function which works in Internet Explorer 11 with the Bosch MPEG ActiveX installed. Due the end-of-life of Internet Explorer, this function is no longer available on Microsoft Edge.
In this article you can find the actions you need to do in order to solve the zoom speed for AUTODOME NDP-7512. A customer could observe a difference in zoom speed in comparison to the previous generation
This guideline will help you set the position of the camera image to an appropriate one. If the picture of the camera is inverted in the live view, please follow the steps below to reverse it.
First recommendation would be to configure the mode for IVA as a trigger, setting IVA as Profile 1 for “trigger off” and IVA as silent for “trigger on”.
You can call desired pre-positions (PTZ) of Bosch IP cameras by using OSRD protocol or BiCom protocol. Please check this aticle to find some examples and detailed explanation.
If ‘Calibration upload to camera failed’ for CPP7.3 & CPP13 Bosch cameras please follow the below steps:
Upgrade Configuration Manager to version 7.61.
This must be used in combination with CPP13 Firmware 8.45 or later