Security: Video

The "Lens rotation" slider can be used to correct for any manual lens rotations performed during installation. If the lens is manually rotated during installation, the slider value should be aligned with the rotation value shown on the lens.

The Image Stabilization cannot be used in combination with VCA tasks, with the various MIC-7100i models. Turning Off the image stabilization will solve this behavior.

We found that there was a change in the way intelligent tracking worked after CPP 7.3 firmware v7.62.0005. With these changes if an object triggered an alarm that turned on intelligent tracking, the camera would not track the object. It would wait for another object to trigger an alarm to track it.

The inconsistency in the tamper detection functionality could be due to various factors. Follow this article for more details.

Unsupported camera model: Auto-calibration is currently not supported for this camera model. Calibration could produce wrong results or might not work. Why is this message displayed in Configuration Manager?

This article presents solution regarding how to stop "rtp.p_type 97" (OSD or Video Authetication packet) on a CPP4 and CPP7.3  

Do not upgrade the camera FW directly to 7.81. Otherwise, “error 13: device check failed” message will be displayed, and the FW will not be upgraded successfully.

This article gives an overview of CPPs that correspond to certain types of cameras, decoders and encoders.

ONVIF control of the thermal DZ was never planned for the MIC-9000i in the launch of the product. However, you can get the Pan and Tilt via ONVIF Device Manager to work by enabling the PTZ configuration of the stream. 

With fw7.70 a new feature was introduced that allows you to tune the scene for Day and Night separately using 2 custom scene modes. This article explains how to switch the scene modes Custom mode#1 & Custom mode#2 based on Day or Night for Bosch cameras

This Authorization Letter is applicable for all Bosch Security and Safety products & software when a password reset for them is requested by customers, system integrators or by a local sales representative.

Find out from this article which Bosch encoders and decoders are compatible with BVMS

BVMS Version 10.0: please note that the export mechanisms provided in the BVMS Configuration Client might not export the user-data. Check this article for more details!

This document is specifically for DIP-71xx as it's the DIP which supports certain versions of BVMS (regular BVMS installer) and must be updated in a certain order. The document details how to upgrade from BVMS v8 to BVMS v12.0.1.

This document is valid for all VideoView+ versions. Only the release notes of the latest VideoView+ version are fully updated and contain updates for earlier versions as well.

According to the DIP Whitepaper, the unit supported 128 channels before upgrading. After upgrade to BVMS >= 11.0, having the MBV-BPLU-DIP base, the channels licenses limit is 256 channels 

Starting from July 2024, it will not be possible to commission new devices via MAC address (Device Layer). Running devices remain untouched until end of life of Device Layer, but new commissioning will be only possible with Remote Portal devices from then on.

Bosch Remote Portal provides the VideoView+ Service which allows to display live video, replay of recorded video on the camera, and a forensic search on Video Security Client. Further the Video Security App (on iOS and Android) can receive push alarm notifications triggered by motion in the camera image, for example. This article explains how to configure this service to display live video, replay of recorded video on the camera, and forensic search on Video Security Client via your Remote Portal account.

Welcome to the 3.6 release of Video Security for Windows, Android and iOS. There are new features in this release!

The following instruction describes how to configure the data disk in a RAID1 configuration on the DIVAR IP all-in-one 4000. Is important to keep in mind that the configuration of the data disks in RAID1 will cause DATA LOSS on the disks used to create the RAID configuration