Security: Video

This account has been locked because of too many failed login attempts. Try again in 39 seconds.

This article explains briefly the basics of SNMP. Declares the basic terms of the protocol. It also explains what part of the protocol is supported by Bosch cameras.

This article contains the username and password of SuperDoctor 5 for Divar IP 7000 AIO

This article provides an answer to the question: Can I restrict the live view or playback in VSC for certain cameras added in DIVAR hybrid 5000? Yes, you can restrict the live view or playback for certain cameras added in DIVAR hybrid 5000 for an user who is using Video Security App.

This article explains the difference between Wide Dynamic Range, High Dynamic Range and Bosch HDR X.

This article provides an answer if can the Operating System of a DIVAR IP Series be upgraded.

This article provides an answer to the question: Can I install Intelligent Insights into DIVAR IP all-in-one 5000?

This article presents what should we check first if Channel 5 & 6 of DSA E2800 are showing as disconnected: Verify if the expansion slots are connected correctly (page 21) Afterwards, wait a few minutes until they load up, and only then start the DSA S2800. Now, you can check in the Configuration Manager to see if the IP addresses need to be changed. Once you verify that they are correct, you can add the Device in Configuration Client.

Camera Counter Reports are available on Bosch IP cameras capable of Essential Video Analytics or Intelligent Video Analytics, which are connected directly to the Remote Portal.

This article presents what symptoms appear in BVMS Operator Client if Time synchronization is wrongly set. Also provides some recommendations about what to do to avoid this symptoms. 

This articles explains what does the User Name column indicate in the BVMS Operator Client LogBook.

Starting on September 30th 2021, Dropbox™ has changed to short-lived access tokens, which expire after four hours. 

To change the camera name in Remote Portal, you need to change the camera's Device name and then re-register the camera to Remote Portal.

What should you do if you tried to drag an drop the device to the cameo window from BVMS Operator Client and instead having the video, it displays the logical tree?

The "storage state failure" alarm doesn't always mean a recording error unless there is a gap at the time of the error for that camera that reported it. It is an error of the iSCSI protocol; it means that when the camera releases the connection for a certain block it has not received a response back from the iSCSI target in a certain time.

Find out from this article what can you do if the Windows product key cannot be activated on your DIVAR IP and if this message was displayed: "This key didn't work, please check it and try again, or try a different key."

To guarantee high quality imaging through the entire range of products, Bosch Security Systems uses a Common Product Platform (CPP).

Find out from this article how can you avoid the MIC Inteox & Starlight 7100i camera wipers getting stuck.

This article explains where to find the Serial-No. of a system. The BOSCH sticker is most important.  For registration and NetApp case creation of the DSA E2700 and the DSA E2800 units only the NetApp S/N of the Controller base unit is relevant. 

This is a living document and the list will be constantly updated. Details can also be found in the BOSCH Product catalogue: