Security: Video

It is advised to use Bosch tools like the Configuration Manager to configure the camera, that does not allow for issues like XSS

This article gives an overview of CPPs that correspond to certain types of cameras, decoders and encoders.

If you have CPP4 cameras with 6.11 firmware (FW) version and you need to upgrade them to the latest version, normally you have to upgrade to an intermediate firmware version first. But where you can find this firmware ?

Both RJ45 and M12 plug connectors are available with IEC 11801:2002 Cat5 compliance. This further simplifies the concurrent use of both connector types within a single system.

This is a known design limitation and has always been present in the mentioned platforms. There are also no plans to correct this behavior.

This article explains how to configure the Bosch ITS and NTCIP licensed versions of IP moving cameras to respond to National Transportation Communications ITS Protocol (NTCIP).

This article shows step by step how to call a FLEXIDOME IP panoramic 5000 camera preposition in Operator Client. 

This article presents solution regarding how to stop "rtp.p_type 97" (OSD or Video Authetication packet) on a CPP4 and CPP7.3  

WD MSD-064G IP SECURITY MICROSD CARD does not support lifespan check for Bosch CPP4 cameras

Check this article and find out how can you fix the bad frozen image and no PTZ, bad images, uncontrollable web-interface, stuck images in Genetec live/recording for AUTODOME IP starlight 7000 HD camera (FW 7.10.0076) integrated in Genetec as VMS. Version 5.9.4

This article explains how to integrate the Bosch MIC IP 7000 HD camera series into any existing analog CCTV system using the Bosch VIDEOJET decoder 3000. The most common integration scenarios are listed below: Simple integration using direct connectivity to analog monitor and joystick, typically found in single camera installation (for example, mobile surveillance vehicles) Integration into an existing analog matrix switcher typically found in large installations (such as for city surveillance)

Do not upgrade the camera FW directly to 7.81. Otherwise, “error 13: device check failed” message will be displayed, and the FW will not be upgraded successfully.

The privacy mask moves around with the image when the MIC IP starlight 7000 HD camera is in PTZ mode. The camera is integrated into a 3rd party Software.

This article is meant to provide you with the step-by-step guide for activating the wiper and the white lights illuminator option, if your camera is equipped with both of them.