Security: Video

Before you can operate your VIDEOJET decoder 7000/ 8000 within your network, it must have a valid IP address for your network and a compatible subnet mask. This articles explains how you can change the IP Address of VIDEOJET decoder 7000/ 8000 using Configuration Manager.

The normal process is to enable Complete memory dump, this will capture in the event there is an Unhandled Exception.

This article explains how you can change the relay mode back to automatic via a script executed when the relay open event is triggered.

The browser supported by Bosch cameras depends on the CPP that camera belongs to and on the Firmware version the camera has.. In web browsers that do not support MPEG-ActiveX, VCA configuration is only possible via Configuration Manager.

The calculation of the storage capacity is done in different way in Configuration Client and VRM Monitor. Check this article and find useful details!

The BVMS 11.1.1 Configuration Manual contains the lists for all components of BVMS, the ports that must be open within a LAN. You can find the used ports list starting with page 346 from the BVMS Configuration Manual.

When login Remote Portal in Configuration Manager v7.20.0067, the following error message is displayed "The remote name could not be resolved: api.remote.boschsecurity.com"

Find out from this article how does the ‘Active profile’ work for Flexidome Multi 7000i camera

Have a look in this article to learn how you can add ONVIF cameras to Configuration Manager through VSG managed by VRM.

The minimum retention time is going to influence the amount of storage needed. The higher the minimum retention time, the more storage space is required. In this article we are going to show you how to add DIVAR IP 5000 EZ in My devices (Configuration Manager) and configure max & min retention time.

The museum mode of Intelligent and Essential Video Analytics is an optimized tracking mode to detect whenever someone tries to reach towards and touch a valuable asset like a museum exhibit. It can also be used in any other application where approaching a sterile zone from a more crowded environment shall be detected.

This articles gives a short introduction to scripting alarm and counter tasks with Intelligent and Essential Video Analytics in FW 7.60. It also provides a broad selection of example scripts for explanation as well as including real world application examples.

This article describes idle and removed object detection with Intelligent or Essential Video Analytics in FW 6.30, how to configure it and what the limitations are.

This article describes the camera tamper detection options available with FW 6.30: Scene too dark / bright, global change, reference image check.

Find out here what could be the cause of the following message displayed on DIVAR IP 7000 R2: "The instruction at 0x6566f31c referenced memory at 0x00000008. The memory could not be read."

This article presents causes and solution regarding NTCIP control of Auto focus, Auto iris and wiper functions.

This article provides solutions regarding how to resolve SD Card Recording Issues with the MIC-7100i IP starlight and Inteox Cameras

Alarm functions include local inputs and relay outputs, plus motion detection in user-defined areas. If an alarm is detected, the DIVAR can: send an e-mail notification and/or FTP push, sound a buzzer and/or display a warning, activate local alarm output

Whenever a central NTP Server is available the recommendation is to synchronize all cameras against the NTP central server.

The firewall configuration dialog is a fixed step in the setup process and will allow automatic configuration of all required firewall settings to run BVMS.