Security: Video

If you want to be able to replay the recording for the complete retention time, you should use VRM replay. VRM should be accessible and added to the VSC

Please find in this article some settings you can do separately for each FLEXIDOME multi 7000i camera imager on the camera’s web page.

"Show VCA items" is a function which works in Internet Explorer 11 with the Bosch MPEG ActiveX installed. Due the end-of-life of Internet Explorer, this function is no longer available on Microsoft Edge.

Check out this article to see how to configure the network switch port if your FLEXIDOME multi 7000i camera is loosing connection

Upon powering on the DIVAR IP all-in-one 7000 system you hear FAN spinning normal, LEDs are blinking at normal frequency and there are no error beep codes. However, there is no display when connected via VGA (or) DVI (or) DP. Check out this article and find out how to fix this!

This article shows how to configure Input Alarm and later search for them in the Event search using Web Interface.

In this article it is explained how to do the initial system setup and how you can upgrade the BVMS installation to a newer version on a DIVAR IP 3000 or DIVAR IP 7000 video management appliance.

This article describes all the steps that will help you to create iSCSI Virtual Disk/LUNs after replacing an HDD on a DIVAR IP 5000 AIO.

There are two methods of working with 3rd party apps: through Remote Portal and Configuration Manager. In this article you will find the step-by-step guide where is described the method using Configuration Manager.

Monitor Group gives operators flexible control over the content of a video wall or allows them to let the system take over this control automatically based on pre-defined scenarios. This article describes how to create a Monitor Group on a decoder VJD 7xxx/ 8xxx in BVMS Configuration Client

Can I mask areas that should not trigger an alarm (e.g. false detection due to sun reflection)?

At startup, a black screen is showing up and it is impossible to boot into the BIOS or attempt a reset by pressing the F7 key. How to fix this?

The latest suitable Image for your DIVAR IP R2 Family Device can be obtained from Bosch Central Support Team. Please provide the SN (serial number) from the DIVAR IP 6000/7000 R2 when contacting Bosch Central Support Team.

This article contains all the steps to restore DIVAR IP 7000 R2 to factory default. Note: By performing the   Initial Factory Setup   on the system,   ALL DATA from the ENTIRE system will be erased.

This article explains step by step how to remotely connect to DIVAR Network or Hybrid via Divar Mobile Viewer App

This article explains w hat is BVMS Operator Client and how this work with cameras in live view mode. 

If you are interested in retrieving the stream of an IP camera using multicast, please check out the options from this article.

This article describes how to set LUNs on a target to Read Only via Configuration Manager.

In this article can be found how many  multi-imager cameras are supported in DIVAR IP AIOs.

In this article is explained step by step how to collect logs from your DIVAR IP all-in-one 4000 & 6000.