Security: Video

Find out from this article what is the domain name used to connect your DIVAR to the Remote Portal

For certain conditions, MIC cameras will display status codes on the video image. What does "status 9" mean on the MIC IP ultra 7100i │ MIC IP starlight 7100i camera's web page ?

Various overlays in the video image provide important status information. But what does mean the blinking play button near the yellow exclamation icon?

If you have CPP4 cameras with 6.11 firmware (FW) version and you need to upgrade them to the latest version, normally you have to upgrade to an intermediate firmware version first. But where you can find this firmware ?

Are you looking for the MIC IP fusion 9000i Wiper/Washer RCP command syntax to incorporate it in the third party software?

Find out from this article what might be the cause that could lead to this message being displayed: “error 18: wrong or no signature”

Let’s suppose that you have one setup which consists in an Adam 6060 I/O module, BVMS and a DINION IP thermal 8000 camera. Can the state of an ADAM relay module be changed when the IVA from the camera generates an alarm?

Follow the steps from this article and find out how you can remotely view and collect the system's event log through IPMI (Intelligent Platform Management Interface).

Do you want to configure Video Content Analysis of your device and "VCA: Authorization required" message is displayed in Configuration Manager? Find out here why this message is displayed and what you should do to fix it.

If your VIDEOJET decoder does not seem to work properly, most likely it is because the software (SW) version used is not compatible with the firmware (FW) version of your device.

DIVAR network 5000 / DIVAR hybrid 5000   support configuration of 3rd party cameras through the ONVIF Profile S protocol.

This article explains how to add new ONVIF cameras to a system that runs in full Bosch Video Management System (BVMS) via the Configuration Client. Depending on the license type you have installed in the Bosch Video Management System (BVMS), you can add a certain number and different types of cameras/ encoders.  BVMS supports 3rd party cameras as well, but they need to be compliant to ONVIF Profile S.

This guide is meant to help you adding new cameras in VRM in Configuration Client and display their images in Operator Client.

Operator Client helps you display the original full image circle of a panoramic camera, its image dewarped or you can select a point of interest of the image.

VSG is specifically designed to provide integration for 3rd party ONVIF, JPEG, RTSP, and legacy H.263 Bosch devices.

Find out from this article if it is a cause for concern if the temperature of FLEXIDOME IP 5000i IR (NDI-5503-AL) is higher than other cameras.

Find out from this article what can you do if the Windows product key cannot be activated on your DIVAR IP and if this message was displayed: "This key didn't work, please check it and try again, or try a different key."

If you want to improve the image quality of your Bosch camera and you did not find the FPS option in the Web User Interface, please follow this article and you will find the answer.

Depending on the FW version of cameras and BVMS version you have installed, different possible situations can occur such as: the cameras are not working because the firmware is old, Configuration Client will display a message like: "unknown platform", Gaps in recordings or not recording at all and so on

If one of DIVARs IP 5000 AIO is selected on a user profile, the Operator Client opens the site and works fine. One message is displayed when two or more DIVARs are added into the same Enterprise system.   If you already have a DIP 5000 AIO into your Enterprise system and you want to add additional units but you receive the following message, you can solve this by using the steps below: "Server of configuration database is already in the server list. Remove either the server that is twice in the list or make sure that the configuration database is not cloned between servers."