Security: Video

In order to determine the Time Zone values, perform the bit mask operation of the flag value with the combined bit mask value 0x1F800000 as shown below. Bits 23-28 correspond to the Time Zone bits in the Flags.

In order to add the Subject Alternative Name, you can use "Bosch Configuration Manager" or the camera's web page using latest Firmware

Bosch recommends that the operating systems used by the video surveillance system are constantly updated, with a maximum update cycle of 6 months. Windows updates often include fixes for recently discovered security vulnerabilities, such as the Heartbleed SSL vulnerability, which affected millions of computers worldwide.

This article explains which is the difference between BVRAdmin lost password versus VRM lost password (reset) of DIVAR IP.

This article explains what is IVA Pro Perimeter and what does 2D & 3D Tracking Parameters mean.

The Virtual Assistant event is mapped to code 751 in the alarm transmitter. It is not possible to differentiate in the alarm transmitter the different scenarios on which an event code should be customized. The event properties sent from the Alarm Management application to the transmitter contains only if it's a VIRTUAL ASSISTANT or LIVE INTERVENTION etc.

Yes. Since the system does not have a valid SMA, the Central Technical Support team cannot perform the license transfer from one unit to the other.

Perform an update in the BVMS setting to pull h265 and the recording should start to show up in the playback cameo from BVMS Operator Client

If you want to disable the digital zoom or to limit the maximum zoom-in of the AUTODOME IP starlight 5100i IR camera, you can do that by using the AUX Command 80 (OFF).

This article explains the meaning of the arrows in circle at the central logical tree in the BVMS Operator Client list

This articles explains what does the User Name column indicate in the BVMS Operator Client LogBook.

This article explains what you can do if no e-mail notification is received from Remote Portal for account activation or password reset

The configured camera TCP port is used from the BVMS Operator Client to the camera. This port is used by the BVMS Operator Client as a destination port. The source port is dynamic and therefore, it cannot be adjusted.

The internal logs are directly located in the folder C:\ProgramData\Bosch\VMS\Log and then are named like "CameoSdkLog_Instance1.txt.0".  To activate the Cameo SDK logging, the "Init" button has to be pressed after setting the checkbox "Internal logging" and entering an instance name - then logging is activated with the given instance name (e.g. "Instance1").

WD MSD-064G IP SECURITY MICROSD CARD does not support lifespan check for Bosch CPP4 cameras

This article provides possible causes and solutions regarding FLEXIDOME Inteox 7100i (CPP13) - calibration lost using FW 8.45.0032.

The MIC IP fusion 9000i supports only simplified Chinese language. There is no option to select traditional Chinese in the menu.

This article gives you the solution when the link to Remote Portal from BVMS v11.0 License Manage is redirecting to the 404 Not Found page

According to the DIP Whitepaper, the unit supported 128 channels before upgrading. After upgrade to BVMS >= 11.0, having the MBV-BPLU-DIP base, the channels licenses limit is 256 channels 

By default, the DIVAR IP all-in-one 7000 devices are intended to operate with one or two local monitors, connected to HDMI interfaces on the rear of the unit. If NO HDMI is connected, then iKVM over BMC port is active and available. In this case, it is supported to remove VGA cover and use it as local admin monitor, not to run the Operator Client.