Security: Video

This FAQ article contains a lot of questions and answers related to Bosch Remote System Management service 

This article contains the CGI commands that help you to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper during boot-up

Find out from this article what should be done when the MIC IP STARLIGHT 7100I cameras pan but do not tilt

This article presents the considerations that should be taken into account when using the conduit adapter NDA-3080-CND for installation: For protection against water ingress we recommend to avoid top entry for the conduit adapter and use the side and bottom entry position Mark the position of the hole of the surface Drill the hole with the appropriate diameter drill Install a plug in the hole Put the cable through the hole of the conduit plate Attach the conduit plate with the conduit plate adapter to the surface Install the conduit cover on the conduit plate. Tighten the two screws with the TR15 Allen key

Both RJ45 and M12 plug connectors are available with IEC 11801:2002 Cat5 compliance. This further simplifies the concurrent use of both connector types within a single system.

The wiring and installation details in this guide are based on common practices used at sites to ensure proper surge and lightning suppression.

If you would like to exclude certain Events and Alarms from being written in the BVMS logbook you do have the option to exclude such information.  

This article contains different Q&A regarding the Camera certificate in Config. Manager & WEB GUI: size limit, supported formats and limitations.

The maximum resolution of 5.3 MP can only be achieved with H.264 encoding

After a power outage/ reboot, all PTZ cameras will get back to their zero-point (home) position. If your PTZ camera was installed looking at a wall, in case of a power outage it will return to its home position where its image is pointing at the wall.

The RCP documentation can be found in the Firmware .zip file on the product page.

This feature is not available in BVMS 10.1. You cannot do it automatically for multiple cameras. You can do it one by one manually through Config Client.

Find out from this article if is it possible to get a raw video stream from a Bosch camera

Due to the product design, the configuration of the NIR-50850-MRP (IP IR Illuminator 5000 MRP) is done only in the web browser. Also, this article contains a short explanation about how to setup the NIR-50850-MRP (IP IR Illuminator 5000 MRP).

The IEEE standards in computer networks ensure communication between various devices; it also helps to make sure that the network service, i.e., the Internet and its related technologies, must follow a set of guidelines and practices so that all the networking devices can communicate and work smoothly. Depending on the camera model, the PoE IEEE standard used could be different. 

In principle, the Autodome starlight 5100i IR camera (NDP-5523-Z30L) may only be operated with switches, midspans or PoE injectors that meet the EEE802.3bt standard! - Or use 24VAC.**

If your VIDEOJET decoder does not seem to work properly, most likely it is because the software (SW) version used is not compatible with the firmware (FW) version of your device.

You may have installed Configuration Manager on your PC, you tried to run it but the software no longer works. What could be the reason?

This article explains how to avoid black lines appearing in the live view of Bosch cameras.

Can a stream of a Bosch camera be integrated into the end-user web page via http(s)?   Yes! You can use stream from our Bosch cameras to be displayed in a web page. Bosch IP cameras have a web server embedded and what you see when connecting to a camera with a web browser is a web page.