Security: Video

This only happens when you perform the export in BVMS Operator Client.

When it comes to maintaining your system uptime, you absolutely have to know when there's a problem, no matter where you are or the time of the day. Therefore, this article helps you learn how to enable Remote Alerts, if something happens on the site and you are not on it.

New check in BVMS Configuration Client has been implemented, which blocks the disabling of the "Secure connection" if camera port 1756 is disabled. This should prevent the camera from getting "unreachable" by miss-configuration of the administrator. 

This article informs you about the way of working of the Central Technical Support when you contact them regarding your faulty  Bosch Security Systems device. 

The Administrator can create groups and even nested groups to organize devices in Remote Portal

This article explains how you can set up a Virtual Assistant service in Bosch Alarm Management

Sometimes it is preferable to have a different “user mode” during the day then in the night. Our cameras by default have the option to switch the user mode e.g. triggered by the camera D/N switch over. But also other triggers can be chosen. Below an example how to setup the “user mode” switching triggered by the D/N switch over.

BP+ (Baseline Profile +) is available in any of the new ARM based chipset encoders, like the VIP-X1 XF.  BP+ is needed for compatibility with Divar and hardware decoders, for example, theVIP XD decoder.

This article presents what are the limitations of Privacy overlay in BVMS 12 (Pano cameras, h.263 & MPEG, decoder, VSC).

This article explains what is the difference between operations mode of a DIVAR IP all-in-one 4000 & 6000.

Answer It only depends on the version of BVMS you have. If you have BVMS 7.5, certain cameras with a certain FW have been tested and are supported. If you have BVMS 8.0, certain cameras with a certain FW have been tested and are supported. For BVMS versions of 9.0 or lower, only tested cameras must be added, otherwise we cannot support new setup. On DIP 3000 you can only upgrade to BVMS 8.0. The version of Windows installed on it does not support older versions of BVMS, it is not compatible. Recommended to use BVMS 8.0, the largest version supported on that unit. You need to make sure that those cameras are on the list of tested devices of the version you have.   Regarding the ONVIF Compatibility of the cameras, please see the following Bosch Knowledge Base article: https://community.boschsecurity.com/t5/Security-Video/BVMS-ONVIF-Device-compatibility/ta-p/4252

The MinIris and MaxIris values could be configured when the camera is mounted and installed in specific lighting conditions.

To be able to deploy a camera with DHCP disabled to Bosch Remote Portal, please perform the steps from this article.

DIP serial number can be found in 2 ways. IPMI information cannot be found within the software and is provided on the device itself. It can be found next to the BMC/IPMI port on the back of the device.

The DIVAR IP units are prepared from production to use at first setup the port 8454.

Central Support Team may ask you to provide them with the log files and configuration file of Intelligent Insights.This article explains you how and where you can get them.

Welcome to the 3.6 release of Video Security for Windows, Android and iOS. There are new features in this release!

The RTC_AUDIO_LOUDSPEAKER_ON_OFF flag is not activated.

Divar 700 uses the concept where it assumes to be the (master) device to have control over the cameras and their streams.

When the lens of FLEXIDOME 5100i camera is set to a higher tilt angle, you might encounter that the tilt is shifting when assembling the bubble, making it challenging to set a specific tilt angle to meet the desired Field of View (FoV).