Welcome to the 2.3.0 release of Project Assistant for Windows, Android and iOS. There are many new features and bug fixes in this release that are detailed in this article.
This article explains how to use the settings as per the devices current configured capabilities if you just added a device to BVMS, you get the possible stream options as per a “Config table” known to BVMS.
For larger projects, where many cameras need to be commissioned, the question might come up on how to tackle it in the most efficient way using the Project Assistant.
One of the main bugfix reasons to use VRM 03.71.0029 is a fix in regards to correct display and replay of recorded clips in continuous and alarm recording mode.
This article describes the considerations that need to be taken into account when designing a video surveillance system that is suitable for person identification.
Check the sample script from this article. It is not a working script, that can be used directly. Follow the instructions in comments of the script to tailor it for your use.
If the Host Type was set to other value than “Factory Default” for DSA E2800 and you want to integrate it with BVMS, the targets will most likely not be scannable and there will be no recordings at all.
This guide covers the necessary software configuration procedures to recover from the following failure scenarios: One Drive Failure, Two Drive Failure or LSI Controller Card Replacement ( Post Physical Installation)
This article contains a step-by-step guide which explains how you can perform a full factory default of DSA E2800 via SANtricity Storage Manager by using Script Editor