Security: Video

Have a look in this article to learn how you can add ONVIF cameras to Configuration Manager through VSG managed by VRM.

The minimum retention time is going to influence the amount of storage needed. The higher the minimum retention time, the more storage space is required. In this article we are going to show you how to add DIVAR IP 5000 EZ in My devices (Configuration Manager) and configure max & min retention time.

AI Alarm Verification is applicable to Bosch Remote Portal cameras and 3rd party cameras**, for sites in Alarm Management which support alarm clip upload. 

This article explains step by step how to load BIOS Optimized defaults on my DIVAR IP 5000 AIO unit.

This article explains step by step how to remotely connect to DIVAR Network or Hybrid via Divar Mobile Viewer App

All Bosch IP cameras that are equipped with a Micro SD can record at the edge. While video recorded via Bosch’s proprietary iSCSI format is none readable, many sites require any type of recorded video to be encrypted.

This article explain step by step how to upgrade the firmware for multiple cameras (bulk) at the same time in Configuration Manager.

This article contains the solution to fix your Z4G4 workstation when "Stop code VIDEO TDR FAILURE. Restart PC" message is displayed

When the camera operates in automatic Night-Mode and the switching interval is too fast the camera built in protection mechanism will intervene to prevent premature wear of the mechanical IR-Cut filter.

The normal process is to enable Complete memory dump, this will capture in the event there is an Unhandled Exception.

Follow the steps below and find out how you can perform the Firmware Upgrade for multiple cameras in bulk

Follow this step-by-step guide and learn how to configure RAID 5 on your DIVAR IP AIO 7000 GEN3.

Follow the steps from this article and learn how you can create RAID 1 on your unit.

This article explains how you can  monitor the hardware health status of the DIVAR IP storage devices → Measure can be taken to repair the device if something fails.

This article contains a step-by-step guide related to updating process of the E-Series controller firmware

This article gives you the solution to fix the behavior when the recording doesn't work for VG4 AutoDome camera and when the Bosch logo is displayed in the cameo

When smoke or fire is been detected, AVIOTEC will sent a Smoke/Fire event to the Alarm Management and at the same time trigger it’s output.  Using this output status, we are able to trigger the Alarm Management.

This article describes the method about how you can import a .txt file containing a group of cameras from Configuration Manager in Project Assistant App.

A DIP 5000 AIO is configured as a JBOD box and if one drive goes bad then you will have to replace that drive and all the data will be lost. Check this article and learn how you can add, replace or change HDDs in DIVAR IP 5000 AIO

This article describes how to add NetApp E2800 expansion units to a running NetApp E2800 system without any data loss.