This article explains how you can monitor the hardware health status of the DIVAR IP storage devices → Measure can be taken to repair the device if something fails.
This article gives you the solution to fix the behavior when the recording doesn't work for VG4 AutoDome camera and when the Bosch logo is displayed in the cameo
When smoke or fire is been detected, AVIOTEC will sent a Smoke/Fire event to the Alarm Management and at the same time trigger it’s output. Using this output status, we are able to trigger the Alarm Management.
This article describes the method about how you can import a .txt file containing a group of cameras from Configuration Manager in Project Assistant App.
A DIP 5000 AIO is configured as a JBOD box and if one drive goes bad then you will have to replace that drive and all the data will be lost. Check this article and learn how you can add, replace or change HDDs in DIVAR IP 5000 AIO
If you use the firmware files that are dedicated to a certain CPP platform, then you will need to select simultaneously only the cameras with the same CPP platform.
This article contains a step-by-step guide which explains how you can perform a full factory default of DSA E2800 via SANtricity Storage Manager by using Script Editor
Relates to: IP Storage/PC HW - DIVAR IP 6000 R2 and DIVAR IP 7000 R2
Both DIVAR IP units running the BIOS from American Megatrends Inc. (A.M.I)
There are PRE BOOT or POST BOOT beeps.
Please see the following Acoustic Error Codes.
This article explains how you can configure the iSCSI ports of your DSA E2800 dual or single controller and afterwards configure it in BVMS Configuration Client.
The purpose of this article is to provide the step-by-step process of adding drives to a DIVAR IP 7000 R1 (DIP-7080-00N) Recording appliance and configure initial RAID setup on it.