Security: Video

This article presents solution regarding how to stop "rtp.p_type 97" (OSD or Video Authetication packet) on a CPP4 and CPP7.3  

With fw7.70 a new feature was introduced that allows you to tune the scene for Day and Night separately using 2 custom scene modes. This article explains how to switch the scene modes Custom mode#1 & Custom mode#2 based on Day or Night for Bosch cameras

The maximum resolution of 5.3 MP can only be achieved with H.264 encoding

ONVIF control of the thermal DZ was never planned for the MIC-9000i in the launch of the product. However, you can get the Pan and Tilt via ONVIF Device Manager to work by enabling the PTZ configuration of the stream. 

This article describes what shoud be done to achieve an Optical Zoom for FLEXIDOME IP 3000i IR camera.

This articol provides solution for  FLEXIDOME IP starlight 8000i about wrong color applied to alarm-triggered bounding boxes (Camera Trainer).

This is a known design limitation and has always been present in the mentioned platforms. There are also no plans to correct this behavior.

The RCPP command to enable/ disable the privacy masks is CONF_PRIV_MSK_POLY - 0x0bd8. Follow this article to see the rcpp command to enable & disable the privacy mask of a Bosch camera (moving or fixed).

This article mentions that the material from which the Surface Mount Box of the NBE-5503-AL is made of is Aluminum.

Please note that this recommendation might help, but cannot guarantee the high quality of the image. It depends on the camera FoV and the environment where the camera is installed.

This article contains some hints about what to do when the FLEXIDOME IP 3000i IR does not provide Analog stream or it provides a grey image

Be sure that the MIC-7100i camera is configured in BVMS Configuration Client with "Bosch-AutoDome Bilinx" protocol and not with "Bosch-AutoDome" protocol or other options from the list.

Bosch requires the installer to provide the specified power mentioned on the product spec sheet and labels. While taking into consideration the POE standards. Bosch doesn't support out-of-spec operation of our cameras as we cannot guarantee proper functionality in such circumstances. Thus, we will not be providing out-of-spec voltage or power values at this stage.

The maximum zoom speed in the GUI is operational but is only applicable during "manual control." When the operator calls for 30x, the zoom speed has to remain constant. While the speed may not be as rapid as anticipated, it is essential to understand that this camera model is already operating at its optimum capacity.

‘Status 11’ means that the wiper is blocked and cannot move freely or cannot move at all. Please check if the wiper is working properly and can move freely.

In case you have noticed a gap between the left and right of the lens installation, this might cause improperly focus for the camera's image. Therefore, please proceed as explained in this article.

The inconsistency in the tamper detection functionality could be due to various factors. Follow this article for more details.

Should the inverter produce a sine/sinusoidal wave, a square wave or other?

Please note that the relay output of the IO Alarm card is a dry contact relay (with 24VAC/VDC, 5 A). In order to control another circuit that has a 230V you can't do that directly because its higher than it was design for. In order to safety control a 230V, you could use a 24V on that output and control an additional/external relay: powering its coil this relay could switch the 230 circuit of the washer.

Mercury vapor lights are banned in many countries. There are a variety of phosphor coatings used by different lighting brands resulting in different color temperatures.