Security: Video

This web page is for information only, so none of the fields displayed can be edited. Although this information is also included in the Log files, this view provides some valuable information at a quick glance.

Find out from this article what to do if the System Overview of Bosch camera shows the I/O controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the IR controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the Motor controller FW version as zeros

Find out from this article what to do if the System Overview of Bosch camera shows the SC or Camera controller FW version as zeros

Any modification of the DIP unit IP, adding of a Network Dongle, moving of the ethernet cable in another network switch, even temporary, will stop the communication between the VRM and BVMS and could lead to issues. (e.g. No recording /iSCSI Target unreachable etc.)

When using Bosch cameras for IVA Calibration performed with Bosch Configuration Manager 7.70.0090, the Scenario selection is not there anymore, and by default it selects bird's eye view.

In this article you will find the ports which are used for Remote System Management

This will let you call up cameras on an Allegiant monitor output across the network to a remote site.

This article shows what to do in case the following message occurs: "Could not add the following devices"  when adding IP cameras FW 7.87  to BVMS 12.0.

This article presents the considerations that should be taken into account when using the conduit adapter NDA-3080-CND for installation: For protection against water ingress we recommend to avoid top entry for the conduit adapter and use the side and bottom entry position Mark the position of the hole of the surface Drill the hole with the appropriate diameter drill Install a plug in the hole Put the cable through the hole of the conduit plate Attach the conduit plate with the conduit plate adapter to the surface Install the conduit cover on the conduit plate. Tighten the two screws with the TR15 Allen key

Find out from this article what should be done when the MIC IP STARLIGHT 7100I cameras pan but do not tilt

The MG Camera Name and Number Setting (BVMS Configuration Client, under MG Camera Settings) was not designed for BVMS Operator Client cameo, but in fact for the CPP-Enc type of decoder like VJD-3000.

BVMS Configuration Client or Operator Client does not display correctly on the DIVAR IP 4000 AIO when opened from the Kiosk mode and appears oversized in fullscreen.

Find out what can you do when in large parts of the zoom range, the MIC IP starlight 7100i camera simply does not focus; this is the same for manual PTZ and pre-sets.

At some point, the Central Technical Support team could ask you to provide them with a Configuration Manager table view export, for further investigation of your devices, such as a full overview of the installed cameras or with the cameras with a specific problem. This article will help you to learn how to do this export.

VIDEOJET decoder 3000 is only capable of decoding H.264 video.

When logging into BVMS Operator Client, there is an alarm showing up: “System Error - Server alarm queue capacity reached”. Find out from this article what could be the cause and how to solve this.

You can lock the control of a PTZ camera for other users. A user with a higher priority can take over the control and lock the camera control. A timeout can be configured for this explicit PTZ locking. If you only take over the control without manually locking it before, the control is locked for the user with lower priority for 5 seconds.

The alarms appear, the forensic search is working fine, but the yellow lines don’t appear on the recording line/ timeline. What to do to display the yellow lines in timeline?