Security: Video

This article presents possible causes and solution regarding no recording for cameras added to VRM (DIP 7000AIO): ‘Unexpected error’ in BVMS Config Client

This document contains information on what situations might happen if no Virtual Guard appears in Alarm Management Operator Interface and how to advise.

The live view of the camera is loading indefinitely in Alarm Management Operator Interface > Live View and Investigation Mode and has no streaming video at all.

This list contains information on what situations might happen if no Smart Notification reaches the mobile device and no event appears in the Site Monitor App's event list:

Have a look in the Knowledge Base and find out the steps to remove a camera from the CBS account!

This document contains information on what situations might happen if no alarm events from a Live Intervention, Video Verification or Virtual Assistant services appear in the Alarm Management Operator Interface and how to advise.

In case of unexpected behavior of the Bosch Forensic Search in Genetec Security Center this page can help during the investigation and in finding the root cause of the problems

This article contains the LIF fie which will help you to activate the Activation Key from SLMS for BVMS Lite v10.0

Learn how to design a network on which BVMS can run comfortably.

Based on the symptoms of no steaming video, a blank diagnostic log and the message below in the logs, there could be a few possible problems. These would be internal hardware issues.  

This article summarizes the BVMS design details, and serves as a guide to planning a BVMS system with Bosch cameras and storage. It focuses on BVMS combined with the VRM.

This article shows what to do in case the following message occurs: "Could not add the following devices"  when adding IP cameras FW 7.87  to BVMS 12.0.

BVMS Configuration Client or Operator Client does not display correctly on the DIVAR IP 4000 AIO when opened from the Kiosk mode and appears oversized in fullscreen.

The timeline is present, but the recordings appear to be black for all cameras.

When logging into BVMS Operator Client, there is an alarm showing up: “System Error - Server alarm queue capacity reached”. Find out from this article what could be the cause and how to solve this.

You can lock the control of a PTZ camera for other users. A user with a higher priority can take over the control and lock the camera control. A timeout can be configured for this explicit PTZ locking. If you only take over the control without manually locking it before, the control is locked for the user with lower priority for 5 seconds.

The alarms appear, the forensic search is working fine, but the yellow lines don’t appear on the recording line/ timeline. What to do to display the yellow lines in timeline?

Find out from this article what to do when the Decoder VJD-7513 with FW 10.31.0005 is displayed in BVMS but: First monitor connected on HDMI to HDMI on monitor shows images. Second monitor connected via a USB-C-to-DP cable to the DP port on the monitor shows no output on the second monitor.

This article explains what to do when a black image occurs during the selection/ switching between Streams or by selecting the recorded videos (locally) when accessing Camera Trainer in Configuration Manager.

When entering in BVMS Operator Client, the camera's image is black and only Transcoding option is available for streams (no stream 1 or 2 , or image pane optimized) Desired result: See the camera's live image