Security: Video

Upon powering on the DIVAR IP all-in-one 7000 system you hear FAN spinning normal, LEDs are blinking at normal frequency and there are no error beep codes. However, there is no display when connected via VGA (or) DVI (or) DP. Check out this article and find out how to fix this!

At startup, a black screen is showing up and it is impossible to boot into the BIOS or attempt a reset by pressing the F7 key. How to fix this?

If  ‘Calibration upload to camera failed’ for CPP7.3 & CPP13 Bosch cameras please follow the below steps: Upgrade Configuration Manager to version 7.61. This must be used in combination with CPP13 Firmware 8.45 or later  

License expansions missing after upgrade to BVMS 11 in Remote Portal. Only 1 x MBV-XCHANPLU license activated instead of 16 x MBV-XCHANPLU. What to do?

This article explains what you shoud do when the display output suddenly shows “System Initializing 91” message on screen, while you are turning on your DIVAR IP 7000 R2

Find out from this article what can be done when your HP Z2 with Windows 10 LTSC 2021 and Nvidia driver has black screen (workstation does not boot up). The secure boot does not recognize this as a valid UEFI combination of OS & video board and blocks the booting.

This is a known design limitation and has always been present in the mentioned platforms. There are also no plans to correct this behavior.

Have a look in the Knowledge Base and find out the steps to remove a camera from the CBS account!

This article provides possible causes and solutions regarding FLEXIDOME Inteox 7100i (CPP13) - calibration lost using FW 8.45.0032.

Essential Video Analytics (VCA) does not work as soon as the image is rotated to 90 degrees (under Initialization) and the camera is restarted. Additionally, the movements or objects are not recognized. As soon as you set "Rotate image" to 0 degrees and set it back to 90 degrees, motion detection via Essential Video Analytics suddenly works again.

Is there a way to request for the panoramic camera de-warped snapshot via URL?

After configuring the Virtual mask in the web browser of Bosch CPP7.3 camera and afterwards going back to the Live view, the Virtual mask appears as Privacy mask and is not transparent and other inappropriate behaviors have been noticed. This happens on the Bosch CPP7.3 cameras that have FW version older than v.7.86.0019

Camera integrated as NTCIP with SUNGUIDE software works great, but as ONVIF there are issues with the focus. When trying to adjust the focus from the SunGuide software, there are no changes with the camera image.

Find out from here what to do if your FLEXIDOME Multi 7000i or FLEXIDOME Multi IR is coming offline sporadically/ disappears from the network

Check this article and find out how you can avoid displaying black image in Operator Client BVMS v11.0

At the initial setup of DIP 7000 AIO R3, when the Software Center has to be installed,  you might get the “Certification Check Failed” error message.

This article shows how  the image quality of AUTODOME inteox 7000i & comparison with AUTODOME 5000i IR camera image can be improved.

When looking at the live view via browser (Dewarped view mode) of FLEXIDOME panoramic 5100i IR camera, the ePTZ controls work only for the 1 top left cameo. This article provides causes and solution regarding this situation. 

This article presents causes and solution regarding NTCIP control of Auto focus, Auto iris and wiper functions.

This article provides solutions regarding how to resolve SD Card Recording Issues with the MIC-7100i IP starlight and Inteox Cameras