Security: Video

In the winter period, if there is no PAN functionality in the camera and despite this, the TILT still works, this could be caused by the snow or ice that might be stuck between the static part of the camera and the moving camera head. Find out from this article how you can prevent this happening.

Waiting For Power - Invalid PoE source was detected during the auto-negotiation. The Pan Motor, Tilt motor, and the heaters will be disabled.

Please note that the relay output of the IO Alarm card is a dry contact relay (with 24VAC/VDC, 5 A). In order to control another circuit that has a 230V you can't do that directly because its higher than it was design for. In order to safety control a 230V, you could use a 24V on that output and control an additional/external relay: powering its coil this relay could switch the 230 circuit of the washer.

For certain conditions, MIC cameras will display status codes on the video image. What does "status 9" mean on the MIC IP ultra 7100i │ MIC IP starlight 7100i camera's web page ?

Be sure that the MIC-7100i camera is configured in BVMS Configuration Client with "Bosch-AutoDome Bilinx" protocol and not with "Bosch-AutoDome" protocol or other options from the list.

This is a known design limitation and has always been present in the mentioned platforms. There are also no plans to correct this behavior.

The inconsistency in the tamper detection functionality could be due to various factors. Follow this article for more details.

This article presents solution regarding how to stop "rtp.p_type 97" (OSD or Video Authetication packet) on a CPP4 and CPP7.3  

ONVIF control of the thermal DZ was never planned for the MIC-9000i in the launch of the product. However, you can get the Pan and Tilt via ONVIF Device Manager to work by enabling the PTZ configuration of the stream. 

According to its Data Sheet, the Flexidome IP 3000i IR camera has 2 options to activate the alarm input. Please refer to the diagram from this article if you would like to get alarm input from some physical sensors.

If you are using the ATSL-script, use the following RCP-CGI command to switch ON-OFF the IR-LED of FLEXIDOME IP 3000i IR camera

This article describes what shoud be done to achieve an Optical Zoom for FLEXIDOME IP 3000i IR camera.

The maximum resolution of 5.3 MP can only be achieved with H.264 encoding

This article contains some hints about what to do when the FLEXIDOME IP 3000i IR does not provide Analog stream or it provides a grey image

This article describe how to configure your camera to get optimize focus as-well during the day as night

This article mentions that the material from which the Surface Mount Box of the NBE-5503-AL is made of is Aluminum.

Check out this article and find out the streaming capabilities of CPP7 & CPP7.3 Bosch IP cameras

This article contains several common questions and answers about Firmware of Bosch MIC IP Starlight 7000i cameras

Find out what can you do when in large parts of the zoom range, the MIC IP starlight 7100i camera simply does not focus; this is the same for manual PTZ and pre-sets.

This article helps you to find a solution for your MIC IP ultra 7100i (CPP 7.3 ) when front end is not available after FW upgrade from 7.62.0005 to 7.70.0126