Security: Video

Check this article and find the difference between unmanaged sites and subsystems (BVMS)

Bosch will undertake a cybersecurity best practice by disabling certain ports on the camera by default. This best practice is being undertaken to reduce potential attack surfaces and limit the exposure of sensitive services, as mentioned in our Data Security Guidebook since years.

New check in BVMS Configuration Client has been implemented, which blocks the disabling of the "Secure connection" if camera port 1756 is disabled. This should prevent the camera from getting "unreachable" by miss-configuration of the administrator. 

The MG Camera Name and Number Setting (BVMS Configuration Client, under MG Camera Settings) was not designed for BVMS Operator Client cameo, but in fact for the CPP-Enc type of decoder like VJD-3000.

During the authentication process with Bosch cameras to a RADIUS server, the event “5400 Authentication failed” occurs. Find out from this article what you can do in this case.

Welcome to the 3.5 release of Video Security for Windows, Android and iOS. There are new features in this release, some of the highlights are explained within this article.

Please configure the same time zone on the PC, download the Remote Portal activation file again and then you will be able to load it into Config Client and license the system.

Maintaining the highest level of data security requires continuous improvements in all the system components - including software and device firmware. Recent changes in the camera firmware are focused on improving the security level overall.

The Bosch camera can make up to two (2) recorded tours. A recorded tour saves all manual camera movements made during the recording, including its rate of pan, tilt and zoom speeds, and other lens setting changes.

You should only subscribe directly to this article (Option 1) or to the software_release_notification label (Option 2) and you will receive a notification in your inbox every time when a new Software version is released and added to the lists within this article.

Different devices, whether cameras or encoders, offer a different amount of processing power for video content analysis (VCA).

Starting with BVMS v10.0, you can leverage VRM Encryption Technology.

Glutton (German: Vielfraß) defines and prevents a camera or multi-channel encoder from mounting and consuming  a large number of  blocks in a very short time.

During the troubleshooting process, the Central Technical Support team often needs to run several different loggers to gain a more complete understanding of the problem.  You can use custom console traces to regroup and run different loggers that are not combined in the default Server Admin list. To create and run custom console traces for Security Center, follow the steps from this article.

If replacing a defective camera, the camera must be the same IP address as the defective device, and it cannot contain a GUID from a different VRM.

The configured camera TCP port is used from the BVMS Operator Client to the camera. This port is used by the BVMS Operator Client as a destination port. The source port is dynamic and therefore, it cannot be adjusted.

Hash Tag "#" is one of the few special characters, which is accepted by the camera, but it cannot be accepted on BVMS side (in order to connect to the camera) — due to the limitations of communication specifics some BVMS components are using. And as a result, communication might not work properly and "No connection" warning message in Operator Client image pane and black screen might occur

When integrating Intelligent Insights with a self-signed certificate, the BVMS operator client always shows an error message when opening a widget in the BVMS operator client image pane. Find out from this article how to solve this behavior!

Network switch has port security on and shuts down a NetApp iSCSI data port (e.g. CH3). This article is only relevant in aspects of network security / port security where MAC addresses are analysed. Some network security applications are capable of sniffing network packets thoroughly enough to pick up MAC addresses on E-Series Controller ports that are not seen in the Storage Array Profile data.

When you request to reset the DIVAR password, the Central Technical Support team provides you with the unlock codes. The unlock codes received from the CTS are valid only for 1 Day. Moreover, please make sure that the date displayed on the Live monitor matches the date you requested the password reset.